Quadra-Fire CASTILE-CCR, CASTILE-MBK, CASTILE-CLG, CASTILE-PMH owner manual

Page 26

R

Castile Pellet Stove

Symptoms	Possible Cause	Corrective Action
Convection blower fails to	#1 snap disc defective.	Replace snap disc.
start.	Blower not plugged in.	Check that blower is plugged into wire har-
	Blower not plugged in.	Check that blower is plugged into wire har-
		ness.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Exhaust blower fails to	Blower not plugged in.	Check that blower is plugged into wire har-
start or does not shut off.		ness.
	Blower is clogged with ash.	Clean exhaust system.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Large, lazy ﬂame, orange	Dirty appliance.	Clean unit, including ﬁrepot, heat exchang-
color. Black ash on glass.	Poor fuel quality, high ash content.	ers and venting system. Remove stainless
		steel bafﬂe from ﬁrebox to clean ash from
		on top of bafﬂe. Clean behind rear brick
		panels. Change fuel brand to premium.
	Firepot clean-out plate not completely	Check that ﬁrepot clean-out plate is fully
	closed.	closed.
		Reduce feed rate using feed rate adjustment
	Excessive amount of fuel.	control rod located inside hopper.
Nuisance shutdowns.	Low ﬂame.	Increase feed by opening feed rate adjust-
		ment control rod located inside hopper.
	Sawdust buildup in hopper.	Clean hopper, see page 29.
	Feed motor is reversing.	Check for good connections between feed
		motor and wire harness.
	Defective thermocouple.	Replace thermocouple.
	Defective control box.	Replace control box.
	Firepot more than 1/2 full.	See page 30 for detailed instructions for
		“High Ash Fuel Content Management”
Appliance calls for heat.	Thermocouple is defective or not properly	Check connections on thermocouple or
Call light illuminates.	plugged in.	replace if defective.
Exhaust blower starts.		A ﬂashing yellow light on the control box
No feed or igniter.		indicates a problem with the thermocouple.
	Defective control box.	Replace control box.

Page 26

250-6422D

October 11, 2005

Image 26

Contents Castile Pellet Stove Castile Pellet Stove Location Back side of left side panelTable of Contents Listing and Code Approvals Appliance Location Design, Installation & Location Fire Safety ConsiderationsGetting Started Thermostat LocationInspect Appliance & Components and Pre-Use Check List Castile Pellet Stove Tools And Supplies NeededMeasuring Standards Fire Risk3Dimensions and Clearances Appliance DimensionsCastile Pellet Stove Clearances to Combustibles UL and ULC Hearth Pad Requirements Exception for Horizontal InstallationsCastile Pellet Stove Hearth Pad Requirements UL and ULC Venting Termination Requirements Vent InformationChimney and Exhaust Connection Example of 3 Elbow-Rear Vent Termination Calculaton Pipe Selection ChartCastile Pellet Stove Equivalent Feet of Pipe See FigureVenting Systems AlcoveCastile Pellet Stove Through The Wall Straight OutDegree Castile Pellet Stove Vertical Through The Wall & VerticalCastile Pellet Stove Masonry Alternate MasonryMobile Home 7Appliance Set-Up Outside Air Kit InstructionsInstalling the Top Vent Adapter Top Vent Adapter InstallationRear Vent and Rear Vent to Top Vent Adapter Installation Castile Pellet Stove Leg Leveling SystemOptional TOP LOG Castile Pellet Stove Thermostat Installation Operating Instructions Fuel Size And Material General Operating InformationCastile Pellet Stove Before Your First Fire Fire CharacteristicsFeed Rate Adjustment Instructions Starting Your First FireFrequently Asked Questions Castile Pellet Stove Iginition CyclesPossible Cause Corrective Action TroubleshootingSymption Page Page Types of Fuel Cleaning Ash Pan Frequency As needed10Maintaining & Servicing Your Appliance TaskCleaning Rods Heat Exchanger TubesCleaning Convection Blower Requires No Lubrication Cleaning the Exhaust Path Frequency As neededCleaning the Hopper Cleaning Exhaust Blower Requires No LubricationCastile Pellet Stove High Ash Fuel Content Maintenance SectionConvection Blower Replacement Exhaust Blower ReplacementIgniter Replacement Thumb ScrewGlass Replacement Reference Materials Component FunctionSnap Disc #1 Convection Blower 125F Vacuum SwitchWiring Harness See .1 below Snap Disc #2 Thermostat Override 175tFCastile Pellet Stove Component Locations Castile Pellet Stove Exploded Views Description Part NumberBeg. Manufacture Date September Part DescriptionCastile Pellet Stove Service Parts and Accessories Service PartsAccessories AppliancesService and Maintenance LOG Date of Service Performed By Description of ServiceCastile Pellet Stove Service and Maintenance LOG Cont’d Lifetime Warranty Castile Pellet Stove Warranty PolicyContact Information Telephone