R
Castile Pellet Stove
F. Thermostat Installation
1. A 12 volt AC thermostat is required to operate this pellet appliance. You may use the included wall mount thermo- stat or purchase an optional programmable thermostat or remote control. It is equipped with an adjustable heat anticipator. The current rating is .05 amps. The anticipator needs to be adjusted to the lowest setting available.
2.When mounting a thermostat on a wall, be sure to follow your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accurate readings. The thermostat should be mounted on an inside wall and not in direct line with the appliance convection air.
NOTE: If the thermostat is located too close to the appliance, you may need to set the temperature setting slightly higher to maintain the desired temperature in your home.
3.There is a 4 screw terminal block located on the back lower right corner of the stove directly above the power cord inlet. The center 2 screws are for the thermostat wires.
CAUTION
Shock hazard.
• Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appliance.
FUSE |
Fuse |
TERMINAL BLOCK |
CENTER 2 SCREWS FOR |
THERMOSTAT WIRES |
POWER OUTLET |
Page 20 | October 11, 2005 |