Quadra-Fire CASTILE-CCR Castile Pellet Stove Tools And Supplies Needed, Measuring Standards

R

Castile Pellet Stove

C. Tools And Supplies Needed

Tools and building supplies normally required for installation, unless installing into an existing masonry fireplace:

Reciprocating Saw	Safety Glasses
Channel Locks	Framing Square
Hammer	Electric Drill & Bits (1/4”)
Phillips Screwdriver	1/4” Self-Tapping Screws
Tape Meausre
Plumb Line	May also need:
Level	Vent Support Straps
Framing Material	Venting Paint
Hi-temp Caulking Material
Gloves

D. Measuring Standards

1.Pipe measurements are from center line to center line.

2.Vertial terminations are measured to top of pipe.

Measure vertical

clearances from

this surface

Measure horizontal

clearances from

this surface

Figure 6.1

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

•Do NOT install substitute components.

Report damaged parts to dealer.

E. Inspect Appliance & Components and Pre-Use Check List

1.	Place the appliance in a location near the
	final installation area and follow the proce-
	dures below:
2.	Open the appliance and remove all the parts
	and articles packed inside the Component
	Pack. Inspect all the parts and glass for ship-
	ping damage. Contact your dealer if any irregu-
	larities are noticed.
3.	All safety warnings have been read and fol-
	lowed.
4.	This Owner’s Manual has been read.
5.	Floor protection requirements have been met.
6.	Venting is properly installed.
7.	The proper clearances from the appliance and
	chimney to combustible materials have been
	met.
8.	The masonry chimney is inspected by a profes-
	sional and is clean, or the factory built metal
	chimney is installed according to the manufac-
	turer’s instructions and clearances.
9.	The chimney meets the required minimum
	height.
10.	All labels have been removed from the glass
	door.
11.	Plated surfaces have been wiped clean, if
	applicable.
12.	Thermostat or remote has been installed.
13.	A power outlet is available nearby.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire

Or any such action that may cause a fire hazard.

Page 6 250-6422D October 11, 2005