Quadra-Fire 7051-158B owner manual Listing and Code Approvals

Page 6

R

EDGE 60 Pellet Fireplace

1Listing and Code Approvals

A.Appliance Certifi cation

Model

EDGE™ 60 Pellet Fireplace

 

 

Laboratory

OMNI Test Laboratories, Inc.

Report No.

061-F-75-6.2

 

 

Type

Solid Fuel Room Heater/Pellet Type

 

 

Standard

ASTM E1509-04, ULC S627-00 and

 

ULC/ORD-C1482 Room Heater Pellet

 

Fuel Burning type and (UM) 84-HUD,

 

Mobile Home Approved.

 

 

FCC

Complies with Part 15 of FCC Rules.

 

Operation is subject to the following

 

two conditions: (1) this device may not

 

cause harmful interference, and (2) this

 

device must accept any interference

 

received, including interference that

 

may cause undesired operation.

 

 

NOTICE: This installation must conform with local codes. In the absence of local codes you must comply with the

ASTM E1509-04, ULC S627-00, (UM) 84-HUD and ULC/ORD-C-1482.

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is used.

The structural integrity of the mobile home fl oor, ceiling, and walls must be maintained.

The appliance must be properly grounded to the frame of the mobile home and use only Listed pellet vent Class “L” or “PL” connector pipe.

A Quadra-Fire Outside Air Kit must be installed in a mobile home installation. You must order the Outside Air Kit sepa- rately.

Note: The appliance is also approved for installation into a shop.

C. Glass Specifi cations

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

D. Electrical Rating

115 VAC, 60 Hz, Start 5 Amps, Run 1.25 Amps

E. Outside Air Kit

Outside Air is required on all installations. You must order the Outside Air Kit separately.

F. BTU & Effi ciency Specifi cations

Emissions Rating:

EPA Compliance

 

 

BTU Input*:

14,620 - 52,000 / hr

 

 

Effi ciency:

83.3%

 

 

Heating Capacity:

2,400 - 3,800 square feet depend-

 

ing on climate zone

 

 

Hopper Capacity:

120 lbs

 

 

Fuels:

Pellets, Shelled Field Corn, Wheat

 

and Black Sunfl ower Seeds

 

 

Shipping Weight:

450 lbs (empty hopper)

 

 

Weight with Full

add approximately 120 lbs

Hopper:

 

 

 

*BTU will vary, depending on the type of fuel you use in your fi replace. Consult your Quadra-Fire dealer for best results.

WARNING! Risk of Fire! Hearth & Home Technologies dis- claims any responsibility for, and the warranty and agency listing will be voided by the below actions.

DO NOT:

Install or operate damaged appliance

Modify appliance

Install other than as instructed by Hearth & Home Technologies

Operate the appliance without fully assembling all components

Overfi re

Install any component not approved by Hearth & Home Technologies

Install parts or components not Listed or approved. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualifi ed installer, service agency or your dealer.

NOTICE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its prod- ucts, their specifi cations and/or price without notice.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

Page 6

7051-158B

December 6, 2011

Image 6
Contents Natural Curved Tuscan Studio Hot glass will cause burnsEdge 60 Pellet Fireplace Serial Number LabelTable of Contents Edge 60 Pellet Fireplace Edge 60 Pellet Fireplace Listing and Code Approvals User’s Guide Operating InstructionsEdge 60 Pellet Fireplace Fire Safety Combustible/Non-Combustible MaterialsFuel Material and Fuel Storage General Operating Information Power SwitchAuto-Clean Firepot System Before Your First FireEdge 60 Pellet Fireplace Filling the Hopper with Fuel Starting Your First FireIgnition Cycles Manual Mode Auto-Clean CycleAutomatic Mode Soft Start Cycle SS-Low / SS-MedBattery Back-up System Optional Edge 60 Pellet Fireplace Battery Back-up System Cont’d Clear SpaceMaintaining & Servicing Your Appliance Quick Reference Maintenance ChartCleaning or Inspection Before Servicing Your ApplianceAccessing Components for Maintenance Edge 60 Pellet Fireplace High Ash Fuel Content MaintenanceAuto-Clean System Inspection & Cleaning Cleaning Ash PanDisposal of Ashes Frequency As needed Cleaning Heat Exchanger, Drop Tube & Exhaust Shop Vac* Example Micro Cleaning KitClinker Cleaning the Glass Cleaning the HopperCleaning Convection Blower Do Not Use Lubrication Cleaning Exhaust Blower Do Not Use LubricationChimney Inspection and Cleaning Troubleshooting for Homeowner Frequently Asked QuestionsPossible Cause Corrective Action Getting Started Appliance LocationFloor Support Inspect Appliance and Components Checklist to Help Determine LocationTools And Supplies Needed DescriptionMaterial is installed. See Item G Crush HazardRecommended Sequence Recommended Locations Framing Dimensions & ClearancesOutside Air Kit is Required for All installations Hearth ExtensionSealing at the Penetration of Building Envelope Frame the FireplaceEdge 60 Pellet Fireplace Construct the Chase 27.1Behind the Mounting Frame Edge 60 Pellet Fireplace Finishing MaterialFlush with the Mounting Frame Protrudes Beyond the Mounting FrameOpening Clearances for the Curved Tuscan and Natural Fronts Opening Clearances for the Studio Front Edge 60 Pellet Fireplace Mantel Fuel Loading Clearances Rise to run ratioEdge 60 Pellet Fireplace Non-Combustible Materials Combustible MaterialsInstallation of Fireplace Position the FireplaceSub-Floor Material & Securing Fireplace Crush Hazard Power Supply Cord Wall Control Wire Shock HazardVertical Installation Back Side of Wall Control with Cover OffVertical Installation Cont’d Horizontal Installation Do not Terminate Vent Vent InformationVenting Termination Minimum Requirements Termination must exhaust above air inlet elevationEdge 60 Pellet Fireplace Avoiding Smoke and Odors Edge 60 Pellet Fireplace Negative Pressure Draft Edge 60 Pellet Fireplace Chimney and Exhaust Connection Equivalent Feet of PipeExample of 3 Elbow-Rear Vent Termination Calculation Edge 60 Pellet Fireplace Pipe Selection Chart Altitude in Thousands of FeetLeft Rear Corner Right Rear Corner Rear of Fireplace Outside Air Inlet LocationsEdge 60 Pellet Fireplace Outside Air Kit Installation Install Outside Air KitVertical Interior Typical Installation Through the Wall & Vertical ExteriorStraight Out Choose which one is best for your installationEdge 60 Pellet Fireplace Through the Wall DegreeMobile Home Installation Rebox. Figures 47.1 Optional Log Set Placement InstructionsAppliance Set-Up Rebox. Figures 47.3Front Installation Replacement Parts Glass ReplacementConvection Blower Replacement Baffl e Removal & Replacement Troubleshooting For Installers Error MessageTop View Fireplace DimensionsReference Materials Rear ViewEdge 60 Pellet Fireplace Component Functions Vacuum Switch Power SupplyPower Switch Overheat Sensor Snap DiscEdge 60 Pellet Fireplace Component Locations View of Left RearEdge 60 Pellet Fireplace Service And Maintenance Log Date of Service Performed By Description of ServiceContact Information Hearth & Home Technologies

7051-158B specifications

The Quadra-Fire 7051-158B is a premier wood-burning fireplace designed for homeowners seeking an efficient and aesthetically pleasing heating solution. This fireplace combines advanced technology with classic design, making it an exceptional choice for any living space.

One of the key features of the 7051-158B is its impressive heating capability. With a maximum heat output of up to 75,000 BTUs, it can effectively warm areas up to 2,500 square feet. This makes it ideal for both large homes and open-concept areas. The fireplace is equipped with a large firebox that can accommodate logs up to 24 inches, allowing for longer burn times and fewer reloads, thereby enhancing convenience for users.

Efficiency is a major focus of the Quadra-Fire 7051-158B. The unit boasts an impressive EPA-certified efficiency rating, which signifies that it burns wood cleanly and effectively, producing minimal smoke and emissions. This not only benefits the environment but also maximizes the warmth generated from each log of wood burned. The unit is designed to maintain a consistent temperature with its advanced combustion technology, which ensures a clean burn while maximizing heat output.

To enhance user experience, the 7051-158B incorporates several technological features. One such innovation is the Quadra-Fire's patented Four-Point Burn Technology, which promotes optimal airflow and combustion. This technology results in a more complete burn, reducing the amount of creosote buildup in the chimney and enhancing safety. The fireplace also comes with an easy-to-use air control system, allowing homeowners to easily adjust the amount of air entering the firebox for customized heat and burn rates.

From a design perspective, the Quadra-Fire 7051-158B offers a perfect blend of traditional and contemporary aesthetics. The elegant exterior is available in various finishes, enabling homeowners to choose an option that complements their decor. Large glass doors provide a captivating view of the flames, creating a cozy ambiance in any room.

In conclusion, the Quadra-Fire 7051-158B stands out as a top choice for wood-burning fireplaces. With its efficient heating capabilities, cutting-edge technology, and beautiful design, it is sure to enhance both the comfort and appeal of your home. Whether you are looking to heat a large space or simply enjoy the warmth of a wood fire, this fireplace provides a reliable and stylish solution.