Quadra-Fire 7051-158B owner manual Edge 60 Pellet Fireplace Component Functions

B. Component Functions

1.Auto-Clean Motor

When describing the location of a component, it is always AS YOU FACE THE FRONT OF THE APPLIANCE.

Location: Behind and under the fi repot on the left side, inside the convection air chamber

Function: It automatically opens and closes the fi repot fl oor so ashes can fall into the ash pan.

2.Auto-Clean Switch

Location: On top of the auto-clean motor

Function: Communicates to the control board when the fi repot

floor is open and when the auto-clean system has completed its cycle and is back in the home (closed) position.

3.12 Volt Battery Back-Up Cable (Optional Accessory)

Location: Plugs into the appliance at the lower left front of the appliance.

Function: An icon will display on the wall control when the appliance has lost main power and is running on battery back-up.

4.Combustion (Exhaust) Blower

Location: Mounted in the bottom right rear of appliance.

Function: Pulls the exhaust from the appliance and pushs it out through the venting system.

5.Control Board

Location: Lower left side of appliance.

Function: Controls the functioning of the appliance and communicates with the wall control. The control board can only be opened by an authorized dealer.

6.Convection Blower

Location: Mounted at the bottom left rear of the appliance

Function: Pushes heated air through the heat exchange system into the room.

7.Door Switch

Location: Mounted on the right side of the fi rebox behind the door handle

Function: Senses when the door is open and will display an icon on the wall control and will turn off the auto-clean system and feed motor for safety.

8.Feed System

Location: On the right side of the appliance and can be removed as an entire assembly. The assembly includes the feed motor, mounting bracket, bearing and feed spring (auger).

Function: The hollow feed spring (auger) pulls pellets up the feed tube from the hopper area and drops them down the feed chute into the fi repot

9.Firepot

Location: Inside fi rebox and is made of high quality ductile iron.

Function: The fl oor of the fi repot automatically opens for cleaning and is operated by the auto-clean fi repot system. The fl oor needs to return to a completely closed position or the appliance will not operate properly.

10.Fuses

Location: One AC fuse and one DC fuse is located on the inside of the control board and a third fuse is located in the power supply. Figures 54.1 & 54.2 on page 54.

Function: The AC fuse operates the igniter and the DC fuse operates all of the other components. The third fuse protects the components in the power supply. A fuse will blow should a short occur and shut off power to the appli- ance. The fuses can only be replaced by an authorized dealer.

11.Heat Exchanger

Location: Behind the baffl e. Remove the cast iron baffl e to access the heat exchanger.

Function: Transfers heat from the exhaust system into the convection air chamber.

12.Hopper Lid Switch

Location: Lower front right side of appliance on the power switch cover.

Function: Senses whether the hopper lid is open and dis- plays an icon on the wall control and will turn off the feed motor.

13.Interlock Switch

Location: Lower front right side of appliance behind power switch.

Function: Causes the auger to stop functioning and will be opened when the appliances slides are extended.

14.Igniter (Heating Element)

Location: Mounted on the base of the fi repot.

Function: Combustion air travels over the red hot igniter creating super heated air that ignites the pellets or other fuels.

15.Power Receptacle

Location: Lower rear of the appliance

Function: Check the wall receptacle for 120 volt, 60 Hz (standard current). Make sure the outlet is grounded and has the correct polarity.