ELECTRICAL INSTALLATION | SS38 Direct Vent Gas Stove |
Electrical Wiring
This stove will work without any electrical supply. Electricity is only needed to operate blower.
NOTE: If installed in mobile home, stove must be bolted securely to floor.
WARNING
Electrical connections should only be performed by a qualified, licensed electrician. Main power must be off when connecting to main electrical power supply or performing service. All wiring shall be in compliance with all local, city and state codes. The appliance, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code ANSI/NFPA 70 (latest edition) and Canadian Electrical Code, CSA C22.1.
| CAUTION | Label all wires before disconnecting when |
|
| |
|
| servicing controls. Wiring errors can cause |
|
| improper and dangerous operation. |
|
|
|
|
| Verify proper operation after servicing. |
Remote Wall mounted Switch
A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. Attach the wall switch in a junction box at the desired location on the wall. Figure 31. Do not extend beyond the wall switch wire length provided.
NOTE: Extended lengths of wire may cause the stove not to function properly. Longer length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.
OFF
PILOT |
| HI |
| ON | TH |
|
| |
|
| TP |
|
| TH/TP |
|
|
| OPTIONAL REMOTE |
|
|
| WALL SWITCH |
|
|
| ON |
ON | OFF | RS | OFF |
|
| ||
|
|
| |
|
|
| OPTIONAL REMOTE |
|
|
| WALL SWITCH |
|
|
| ON |
|
|
| OFF |
Figure 31 -
Wiring Diagram for Wall Switch
46D0232 | 23 |