Monessen Hearth SS38 Installing Louvers, Do not use open flame to check for gas leaks

SS38 Direct Vent Gas Stove STOVE INSTALLATION

1.Check gas type. The gas supply must be the same as stated on the appliance’s rating decal. If the gas supply is different from the stove, STOP! Do not install the appliance. Contact your dealer immediately.

2. To ease installation, a 30" (mm) flex line with manual shut-off valve has been provided with on this appliance. Install and attach 1/2" gas line onto shut-off valve.

3. After completing gas line connection, purge air
from gas line and test all gas joints from the gas
meter to the stove for leaks. Use a soap and water
solution or a gas sniffer.	Pressure
4. To adjust flame height, turn HI/LO knob to HI to get	Test “IN”
maximum pressure to burner. Turn HI/LO knob to
LO to get minimum pressure.	Pressure	FP1979
5. To check gas pressures at valve, turn captured	Test “OUT”
screw counter clockwise 2 or 3 turns and then place	HI/LO Knob
tubing to pressure gauge over test point. Turn unit
	Pilot Adjustment Screw
to high. Figure 29. After taking pressure reading,
be sure and turn captured screw clockwise firmly		Figure 29 -
to reseal. Do not over torque. Check test points for		Gas Pressure Check at Gas Valve
gas leaks with a soap and water solution.

WARNING

INSTALLING LOUVERS

Do not use open flame to check for gas leaks.

Attach the top louver unit (two louvers and two louver brackets) to stove with four (4) screws provided — two (2) on each side. Figure 30. Repeat for bottom louver unit.

Louver Bracket

Louver

Bracket

Louvers Screws

Figure 30 - Installing Louvers

ST1113

22 46D0232