Hatco IMPERIAL "S manual Accessories, Stainless Steel Adjustable Legs, Floor Mounting Hardware

Page 31

ACCESSORIES

STAINLESS STEEL ADJUSTABLE LEGS

1. Carefully place unit on its side.

CAUTION

Do not lay unit on the side with the control panel or damage to unit could occur.

2.Thread the adjustable legs into the existing leg holes on the bottom of the unit. (See Figure 21.)

3.After all legs are secure, return the unit to the upright position.

NOTE: If unit is not level, use an adjustable open- end wrench to adjust the foot of each leg until unit is level. Each leg is adjustable from 6" (152 mm) to 7" (178 mm).

FLOOR MOUNTING HARDWARE

Stainless steel adjustable legs with deck mounting flange are available for securing the booster heater to the floor.

SHOCK ABSORBER

The shock absorber installed between the booster and the commercial dishwasher prevents hydraulic shock induced by rapidly operating valves. The shock can cause damage to the equipment.

Figure 21. Optional Stainless Steel Adjustable Legs

BLENDED PHOSPHATE WATER TREATMENT SYSTEM

The Blended Phosphate Water Treatment System is installed before the booster heater and reduces mineral scale build-up by introducing a measured amount of polyphosphate into the water.

29	Form No. EBOOSTERM-0406

Image 31

Contents Electric Booster Water Heaters Important Owner Information ContentsIntroduction Important Safety Information Important Safety Information Important Safety Information Compact Models C Series Model DescriptionsALL Models Imperial Models S SeriesCircuit Breaker & Fused Disconnect Switch Sizes 4 to 12 kW SpecificationsFuse Size Wire Size Volts Phase Amp Draw Breaker or Copper N d u i tCircuit Breaker & Fused Disconnect Switch Sizes 36 to 57 kW Boosters Rated AT 30F 16C Rise Sizing Chart for LOW-TEMP DishmachinesSpecifications Electric Compact Booster Imperial Booster Booster Heater Sizing ChartWM-5C FW4 Stpc Stpcw Capacity MINI-COMPACT MC Series Model 40F 22C Rise 70F 39C Rise Shipping WeightCapacity Imperial S Series Capacity Compact C SeriesDimensions Imperial S Series Dimensions MINI-COMPACT MC Series InstallationLocation Installing Legs Mounting Brackets with Hardware Temperature/Pressure GaugeTemperature Pressure Relief Valve Leg Pressure Reducing ValveFor Installing Pressure Pressure and Temperature Relief ValvesPlumbing Connections TEMPERATURE/PRESSURE GaugesPressure Reducing Valve Blended Phosphate Water Treatment System OptionalRefer to , 9, 10, 11 or InletPlumbing Connections Imperial S Series Form No. EBOOSTERM-0406 Outlet General ELECTRICAL-ALL Sizes and VoltagesSystem START-UP OperationShut Down General MaintenanceHigh Temperature Limit Safety Switch Thermostat AdjustmentBlended Phosphate Treatment System Optional Shock Absorber AccessoriesStainless Steel Adjustable Legs Floor Mounting HardwareTroubleshooting Symptom Probable Cause Corrective Action Troubleshooting Troubleshooting Product Warranty Hatco Limited WarrantyForm No. EBOOSTERM-0406 Form No. EBOOSTERM-0406 Form No. EBOOSTERM-0406 Hatco Authorized Parts Distributors