Trane VAV-SVN01E-EN, Trane manual Unit Installation, Single-Duct, Dual-Duct

Page 18

Unit Installation

Due to their weight, theVAV terminal units should be suspended from the uppermost ceiling, independent of the false ceiling grid. Suspension devices are to be supplied by the installer. Units must be installed level and upright. Failure to level the unit properly may prevent proper operation of the controls and/or terminal unit. Units are not designed to be installed vertically. Consequently, this will also void the UL ratings and any warranty on the unit.

Single-Duct

Depending upon the size and weight of the single-duct unit, it may be capable of being supported by the ductwork that is connected to it. No hanger brackets are provided on these units since the unit should be supported by means of a hanger strap.The hanger strap should be secured directly to the unit casing as shown in Figure 4.

For cooling only single-duct units or single-duct units with hot water coil, the unt may be rotated 180° for opposite side connections.

For units with electric heat, the unit must be ordered from the factory designating either right- or left-hand connections.

Figure 4

Single-Duct Hanging

Recommendations

Dual-Duct

Dual-duct units should be supported by either hanger straps or by using a threaded rod in conjunction with the hanger brackets that are provided on the unit. See Figure 5.

Figure 5

Dual-Duct Hanger Bracket Locations

A

C

AIR

AIR

VALVE

VALVE

COOLING

HEATING

B

TOP VIEW

Inlet Size

A

B

C

 

 

 

 

5" thru 10"

23.154" (588 mm)

25.25" (641 mm)

1.376" (35 mm)

 

 

 

 

12" thru 16"

25.154" (639 mm)

37.25" (946 mm)

1.376" (35 mm)

 

 

 

 

18

VAV-SVN01E-EN

Image 18
Contents Installation Operator Maintenance JuneAmerican Standard All rights reserved Contents Fiberglass Wool Single-Duct Units Vcef Door Interlocking Power Disconnect Digit 7, 8-Secondary AirValve Dual-Duct UnitsDigit 1, 2, 3-UnitType Digit 9-Not UsedFan-Powered Parallel Units Vpef Door Interlocking Power DisconnectService Model Number Description Digit 32-Airflow SwitchFan-Powered Series Units Vsef Door Interlocking Power DisconnectFan Note See fan curves for specific airflows Digit 27, 28, 29-Electric Heat Kilowatts Fan-Powered Low-Height Parallel Units Lpef Door Interlocking Power DisconnectDigit 27, 28, 29-Electric HeatVoltage Fan-Powered Low-Height Series Units Lsef Door Interlocking Power DisconnectDigit 32-Air Flow Switch Literature Contents General InformationReceiving and Handling Unit Information Single-Duct UnitsDual-Duct Units Fan-Powered and Fan-Powered Low-Height Units Typical Fan-Powered UnitsUnit Installation Single-DuctDual-Duct Fan-Powered Standard and Low- Height Parallel Hanger Bracket Locations SizesSeries Hanger Bracket Locations Low-Height Parallel 08SQ/09SQ w/ Hot Water or Electric Heat Low-Height Parallel10SQ Low-Height Series 08SQ/09SQ w/ Hot Water or Electric Heat Low-Height Series 10SQ w/ Hot Water or Electric Heat Attenuator Installation-Parallel Units Attenuator Installation-Series Units Attenuator Installation-Low-Height Parallel Units Attenuator Installation-Low-Height Series Units Chart 1 UnitWeights Parallel Fan-Powered UnitsVsef w Series Fan-Powered UnitVscf w Low-Height Parallel UnitsEquipment Damage Chart 3- Fan Motor Amperage Unit SetupChart 2 Flow Sensor Delta P vs.Airflow Delivery Maximum PSC Fan MotorAmperage FLAHazardousVoltage Electrically Commutated Motor ECMChart 4 -VPxF 03SQ ECM CFMTable VPxF 03SQMotor Min CFM Motor Max CFM Chart 5 -VPxF 04SQ ECM CFMTable VPxF 04SQChart 6 -VPxF 05SQ ECM CFMTable VPxF 05SQChart 7 -VPxF 06SQ ECM CFMTable VPxF 06SQChart 8 -VSxF 03SQ ECM CFMTable VSxF 03SQChart 9-VSxF 04SQ ECM CFMTable VSxF 04SQChart 10-VSxF 05SQ ECM CFMTable VSxF 05SQChart 11-VSxF 06SQ ECM CFMTable VSxF 06SQChart 12- LPxF 08SQ ECM CFMTable LPxF 08SQChart 13- LPxF 09SQ ECM CFMTable LPxF 09SQChart 14- LSxF 08SQ ECM CFMTable LSxF 08SQChart 15- LSxF 09SQ ECM CFMTable LSxF 09SQChart 15- LSxF 10SQ ECM CFMTable LSxF 10SQWiring Diagrams Single-Duct Units Electronic or DDC/UCMSingle-Duct Units Pneumatic Controls Fan-Powered Units Electronic or DDC/UCM Fan-Powered Units Pneumatic Controls Fan-Powered Control Boxes Fan-Powered Units with ECM Fan-Powered Low-Height Units Fan-Powered Low-Height Units with ECM Maintenance Rotating ComponentsBar Ceiling Installation of DiffusersGeneral Concealed Spline CeilingMaintenance/ Service Log Date Tag Serial # Service NotesMaintenance/ Service Log VAV-SVN01E-EN Trane

VAV-SVN01E-EN, Trane specifications

The Trane VAV-SVN01E-EN is an advanced variable air volume (VAV) system designed to optimize indoor air quality and energy efficiency in commercial buildings. This system is part of Trane’s commitment to offering reliable, innovative HVAC solutions that meet the demands of modern architectural designs and energy standards.

One of the main features of the VAV-SVN01E-EN is its ability to control air flow based on occupancy and environmental conditions. This ensures that energy is used efficiently, as airflow can be adjusted to match real-time needs, rather than operating at a constant rate. The integration of intelligent sensors allows the system to adapt dynamically, leading to both reduced energy consumption and improved comfort for building occupants.

The technology behind the VAV-SVN01E-EN includes advanced digital controls and integration capabilities. These controls enable the system to communicate seamlessly with building management systems (BMS), allowing for centralized monitoring and management. This interconnected approach not only enhances operational efficiency but also enables predictive maintenance, helping facility managers identify and address potential issues before they become problematic.

Energy efficiency is further enhanced through the use of VAV technology, which reduces the amount of conditioned air delivered when spaces are unoccupied or when less cooling or heating is required. This tailored approach contributes to lower energy costs and supports sustainability initiatives by decreasing the overall carbon footprint of the building.

Key characteristics of the Trane VAV-SVN01E-EN include its compact design, which facilitates easy installation in existing spaces without significant modifications. The unit is also designed for low sound levels, ensuring that it operates quietly, contributing to a more pleasant indoor environment. Moreover, the VAV system is engineered to be reliable and durable, with rigorous testing and high-quality components ensuring long-term performance.

In summary, the Trane VAV-SVN01E-EN stands out in the field of HVAC solutions, bringing together advanced technology, energy efficiency, and user comfort. Its features are tailored for modern building requirements, making it a preferred choice for facility managers aiming to enhance indoor air quality while reducing operational costs.