Honeywell LYNXR-2 manual Defining the AUX Function, Performing the AUX function

USER FUNCTIONS

AUX Function

General Information

The

AUX

key may have been programmed to either perform a predefined function or to send a preset

message to a pager/”Follow Me” system phone number (see Pager Feature section for pager operation or the Follow Me Announcement Feature section for “Follow Me” operation). Ask your installer which function has been assigned for your system.

AUX

Key: PRE-DEFINED FUNCTION PAGING FUNCTION FOLLOW ME VOICE MESSAGE

If programmed for the AUX function, you can use the

AUX

key to activate a string of up to 20

keystrokes that have been stored in the system’s memory. Typical functions include:

•Seldom used but repeatable sequences

•Arming sequences that involve bypassing zones before arming

•Device activation sequences

Defining the AUX Function

The system must be disarmed before defining a function.

1.Enter

Master user code

+ FUNCTION + AUX (hold down at least 2 seconds until 4 beeps sound).

2.Press the desired command sequence, up to 20 keystrokes. Press the command in the sequence.

3.Press the AUX key twice to end the definition.

AUX

key between each

For example, to bypass Zones 10 and 11 and arm AWAY with NO DELAY, enter the following string:

+ FUNCTION + AUX + [6] + [10] + [11] + AUX + AWAY + [0] + AUX + AUX Master user code

Note that the

AUX

key is included in the 20 keystroke maximum.

Performing the AUX function

Press and hold down the AUX key (hold down at least 2 seconds until 4 beeps sound), then enter

The defined function will begin.

Your user code

– 28 –