1.Measure the existing wall sleeve.
2.See the section that matches the dimensions of the existing wall sleeve.
5.Attach the rear grille using #8 - 32 sheet metal screws (provided).
A
E
D
C
A. Width (W) D. Horizontal insulation strip
B. Height (H) E. Vertical insulation strip C. Depth (D)
B
Insert the 4 - #8 - 32 sheet metal screws (provided) through the holes in the grille and into the wall sleeve.
Wall sleeve dimensions (W x H x D):
25¹⁄₂" x 15¹⁄₄" x 17¹⁄₂" (64.8 cm x 38.7 cm x 44.5 cm), 25³⁄₄" x 16⁷⁄₈" x 18⁵⁄₈" (65.4 cm x 42.9 cm x 47.3 cm), 25⁷⁄₈" x 16¹⁄₂" x 17¹⁄₂" (65.7 cm x 41.9 cm x 44.5 cm) or 26" x 15⁵⁄₈" x 16⁷⁄₈" (66 cm x 39.7 cm x 42.9 cm)
1.Remove the existing grille from the wall sleeve.
2.Remove all debris from inside the wall sleeve.
3.Insert new grille into wall sleeve.
NOTE: Make sure that the word “Top” is readable from inside the room.
4.Using the grille as a template, mark locations of 2 holes on each side of the wall sleeve. Drill ¹⁄₈" holes into the wall sleeve.
A | A |
A. Drill ¹⁄₈" holes into the wall sleeve.
Wall sleeve dimensions:
26³⁄₄" x 15³⁄₄" x 15" (68 cm x 40 cm x 38.1 cm),
27" x 16³⁄₄" x 16³⁄₄" (68.6 cm x 42.6 cm x 42.6 cm), or 27" x 16³⁄₄" x 19³⁄₄" (68.6 cm x 42.6 cm x 50.2 cm)
These sleeves require a larger rear grille and installation parts than the ones provided with this air conditioner. See your local supplier for a kit to fit this size wall sleeve.
NOTE: If you install your new air condtioner into this size wall sleeve without using the kit, you will cause damage to your new air conditioner and the warranty will be void.
PlasticGrilleInstallation
1.Cut the plastic grille 26¹⁄₂" (67.3 cm) wide and 15¹⁄₂" (39.4 cm) high.
2.Place the plastic grille inside the wall sleeve at the rear flange.
6