the dash mounted LED's flash pattern. The number of flashes identifies the triggered zone. For additional information, refer to INTRUSION WARNING SIGNALS found later in this manual.
INTRUSIONWARNINGSIGNAL
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern.
If the LED flashes one time...pause, one time...pause etc., then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. Check the vehicle for possible damage to the glass or body panels.
If the LED flashes two times...pause, two times...pause etc., then an intrusion attempt was made to open the hood, trunk, or by an accessory triggering device. Check the vehicle for indications of forced entry to these openings.
If the LED flashes three times...pause, three times...pause etc., then an intrusion attempt was made to the vehicle doors. Check all doors for indications of forced entry.
Note: The LED intrusion warning indications are stored in the system's memory and will be erased when the ignition switch is turned on.
VALET/SYSTEM OVERRIDE SWITCH
The valet switch allows you to temporarily
1.Start with the valet switch in the "off" position
2.Turn the ignition switch to the "on" position.
3.Within 10 seconds of step 2, flip the valet switch to the "on" position.
The dash mounted LED will turn on solid indicating that the valet mode has successfully been entered.
To return to the normal, (alarm mode), operation, move the valet switch to the "off" position any time the ignition switch is in the on position.
Note: In the event that you lose your keychain transmitter or the transmitter fails to operate the alarm system, the valet switch can be used to disarm the alarm. To disarm the alarm:
1.Open the door with the vehicle door key. (The siren will sound)
2.Turn the ignition switch to the on position.
3.Flip the valet/override switch to the on position.
The system will disarm and the vehicle can be operated normally.
Always remember to move the valet switch to the off position to ensure the vehicle remains protected at all times.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm & disarm chirps by holding the transmitter button slightly longer when arming and disarming. This will prevent the siren chirps for one arm or disarm cycle. If you find this inconvenient and wish to eliminate these chirps permanently,
Page 4
128-5027
4 of 24