Operating Onautomatic Start UP Timer Mode

To Remote Start The Vehicle:

Press and release channel 2 of your keychain transmitter two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 10 or 15 minutes. As a visual indication, the parking lights will flash or turn on dependent on the programming set up by your installation center.

When you arrive at your vehicle, disarm the alarm system by pressing and releasing the arm/ disarm button of your keychain transmitter. Enter the vehicle and turn the ignition key to the on position.

CAUTION! Do not turn the key to the start position. This will cause the starter motor to engage with the already running engine which could result in damage. Step on the brake pedal to disengage the remote start unit. The vehicle will continue to run but now on it's own power. NOTE: The engine will stop running before the expiration of the pre-programmed run timer if you complete any of the following:

1.Press and release channel 2 of your keychain transmitter two times within 2 seconds.

2.Depress the brake pedal.

3.Open the hood.

4.Move the red handled control switch to the off position.

5.Race the engine to above 4000 RPM.

OPERATING ONAUTOMATIC START UP TIMER MODE

The APS-750 has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine.

CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if the car is garaged.

TO BEGIN THE AUTOMATIC START UP TIMER

1.Turn the ignition key on then off.

2.Within 10 seconds, activate the RF start command two times. (Push the second channel button of your keychain transmitter 4 times).

The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.

The vehicle, on a 2 or 4 hour interval basis, will automatically start, run for the pre-pro- grammed time (10 of 15 minutes), and then shut off. This will continue for 48 hours. NOTE: The automatic start up timer can also be initiated from the keychain transmitter. To do this:

1.Start the vehicle using the keychain transmitter by pressing and releasing the second channel transmitter button 2 times.

2.Shut off the vehicle using the keychain transmitter by pressing and releasing the second channel transmitter button 2 times.

3.Within 10 seconds of step 2, activate the RF start command two times. (Push the second channel button of your keychain transmitter 4 times).

The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.

Page 6

128-5027

6 of 24