New Buck Corporation MODEL FP-327-ZC manual Igniter Electrode Thermo-Couple, O.D.S Pilot Burner

Page 29
IGNITER ELECTRODE

IGNITER ELECTRODE

THERMO-COUPLEO.D.S PILOT BURNER

13.Close the access panel door.

14.“Turn on all electric power to the appliance.”

O.D.S PILOT BURNER

PILOT

TO TURN OFF GAS TO APPLIANCE

SHUTTING OFF UNIT:

1.Open access panel door, located in lower front center of base for access to control knobs.

2.Set thermostat (flame control) to lowest setting.

3.Turn control knob clockwise TO TURN OFF GAS TO APPLIANCE to the full “OFF” position.

4.“Turn off all electrical power to the appliance if service is to be performed.”

5.Close access panel door.

SHUTTING OFF BURNER ONLY (pilot stays lit)

1.Open access panel door, located in lower front center of base for access to control knobs.

2.Turn control knob clockwise Manual background to the “PILOT” position.

3.Close access panel door.

Page 27

Image 29
Contents NEW BUCK CORPORATION MODEL FP-327-ZCManufacturer NEW BUCK CORPORATION P.O. Box 8000 Highway 226 South Spruce Pine, NCPage TABLE OF CONTENTS Page SECTION I SAFETY INFORMATION WARNINGS Page Page CHOOSING THE LOCATION FOR YOUR FIREPLACE SECTION ZERO CLEARANCE INSTALLATIONGAS LINE DRAFTS3 1/4 Fireplace and Framing Dimensions inches7 1/2 PageFIREPLACE CLEARANCES INSTALLING THE FIREBOXInstall the Firebox Framing the FireboxCLEARANCES FINISHING YOUR FIREPLACEMUST BE FOLLOWED MANTEL PROFILES FOR ZERO CLEARANCE CABINETMANTEL 3/4 FLAT SURFACE MANTEL 3/4 FLAT SURFACEWITH OPTIONAL WOODEN MANTEL INSTALLATION OF MODEL FP - 327- ZCTOP MANTEL 1/2 WOOD SCREWSREAR OF HEATER MANTEL BASESECTION AFTER MARKET MOBILE HOME INSTALLATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATION PRODUCING ADEQUATE VENTILATIONVent-freeheater VENTILATION AIR FROM INSIDE BUILDING VENTILATION AIRVENTILATION AIR FROM OUTDOORS FLAME GAS CONNECTIONGAS PRESSURE CHECK PLACEMENT OF LOGSSEE DIAGRAM ON PAGE Page PLACEMENT OF LOGS3 1 2 Figure WHAT TO DO IF YOU SMELL GAS FOR YOUR SAFETY, READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS MILLIVOLT VALVE ITT BEFORE INSTALLING THERMOSTAT ROCKER SWITCHREMOVE METAL CONNECTOR PagePILOT BURNER IGNITOR ELECTRODETHERMO--COUPLEPILE PageTHERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDUREFOR YOUR SAFETY, READ BEFORE LIGHTING LIGHTING INSTRUCTIONS MODULATING VALVEMAXITROLto IGNITE and LIGHTING INSTRUCTIONSfor “LOW” for “HIGH”TO TURN OFF GAS TO APPLIANCE IGNITER ELECTRODE THERMO-COUPLEO.D.S PILOT BURNER THERMOSTAT CONTROL OPERATION MANUAL LIGHTING PROCEDURENATURAL PILOT FLAME CHECKBURNER PROPANE PILOTWIRING DIAGRAM Page NOTE #PESBRO84 Blower Model FP-327-ZCRating 120 volts/60HZ/0.54 Amps CLEANING IMPORTANT SAFEGUARDSTROUBLE SHOOTING Air in gas lines when OBSERVED PROBLEM OBSERVED SERVICING REPAIR PARTSMaxitrol Valve PARTS LISTPage BLOWN UP VIEW OF BURNER ASSEMBLYPARTS LIST ITT ValvePage BLOWN UP VIEW OF BURNER ASSEMBLYPage Page