Heat & Glo LifeStyle EXCLAIM-36H-C, EXCLAIM-36T-C Operating Instructions, General Information

Page 28

9

Operating Instructions

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WARNING

 

 

WARNING

 

Fire Risk

 

 

HOT! DO NOT TOUCH.

 

 

 

SEVERE BURNS MAY RESULT.

 

• Do not operate fireplace before

 

 

 

 

 

CLOTHING IGNITION MAY RESULT.

 

reading and understanding operating

 

 

Glass and other surfaces are hot during

 

instructions.

 

 

 

 

 

operation and cool down.

 

Failure to operate fireplace properly may

 

 

 

 

 

 

 

 

cause fire.

 

Keep children away.

 

 

 

 

 

 

• CAREFULLY SUPERVISE children in same room as

A. General Information

 

fireplace.

Alert children and adults to hazards of high

Fireplaces, as well as other woodburning appliances, have

 

temperatures.

been used safely for many years. It has been our experience

Do NOT operate with protective barriers removed.

that most problems are caused by improper installation and

Keep clothing, furniture, draperies and other

operation of the fireplace. Make certain that installation and

 

combustibles away.

operation of the fireplace system is in accordance with these

 

 

 

 

 

 

instructions.

 

 

 

 

WARNING

It is extremely important that the fire be supervised when-

 

ever the fireplace is in use. It is also recommended that an

 

Fire Risk

annual inspection be performed on the fireplace system to

 

 

• For use with solid wood fuel or decorative gas

determine if the flue system needs to be cleaned, or as in

 

 

appliance only.

the case of any appliance, if minor repairs are required to

 

 

• Do not install unvented gas logs.

maintain the system in top operating condition.

 

 

 

 

 

 

 

 

 

open

 

Damper

CLOSE

 

Handle

 

 

Handle up - open

 

 

Handle down - closed

 

 

Figure 9.1 General Operating Parts

 

28

Heat & Glo • EXCLAIM-36C Woodburning Fireplace • 4013-093 Rev G • 08/06

Image 28
Contents EXCLAIM-36H-C EXCLAIM-36T-C Fire RiskGrate Listing Label Information/LocationNumber Table of Contents Appliance Certification Listing and Code ApprovalsNot intended for use as a primary heat source Design and Installation Considerations Getting StartedNegative Pressure Asphyxiation RiskMarginal Location Typical Fireplace System Typical Fireplace SystemInspect Fireplace and Components Tools and Supplies NeededFire Risk Explosion Risk Framing and Clearances Selecting Fireplace LocationClearances Failure to comply may cause fireSidewalls/Surrounds Frame the FireplaceConstruct the Chase Chimney RequirementsInstallation of Fireplace Install the Outside Air KitFire Risk Sharp Edges Asphyxiation Risk Risk of Smoke SpillageFt min. from top of uppermost chimney section to air inlet Secure the Fireplace Position the FireplacePlace the Protective Metal Hearth Strips Level the FireplaceChimney Assembly Height of Chimney Components Using Offsets/Returns ¨ TableInstall the Ceiling Firestops Assemble the Chimney SectionsDouble-check the Chimney Assembly Install the Attic Insulation ShieldSecure the Chimney Complete the Enclosure Chimney TerminationInstall the Chimney Air Kit required in Canada Install the Termination CapChase Top Installing an ST475 Square Termination Cap Gas Log/Lighter Provisions AccessoriesGas Code, Ansi Z223.1 Finishing Hearth ExtensionRaised Hearth Extension Finishing Material MantelGlass Doors Combustible MaterialOperating Instructions General InformationOutside Air Clear Space Near the FireplaceFlue Damper FirescreenGrate Wood FuelFirewood MoistureStarting a Fire Troubleshooting Understanding Vent ProblemsDiagnostics and Problem Solving Diagnostic QuestionsSolutions Can’t get a good fire going. What am I doing wrong?fireplace burns the wood too fast. What can I do? Maintenance and Servicing the Fireplace Chimney Inspection/CleaningDisposal of Ashes Firebox RefractoryMaintenance Task List When cleaning glass doorClean Chimney FireFireplace Dimensions Reference MaterialsFireplace Components Catalog # DescriptionChimney Components Catalog #330 mm 51 mm 14-3/4 375 mm This page intentionally left blank Minimum Base Dimensions 28 X 28 with 32 X 32 with 23 X Minimum Base Dimensions 26.5 X 28 with 34 X 34 withTR442 TR442 / 444 TV 20 xService Parts EXCLAIM-36-C Series Service PartsDescription of Part EXCLAIM-36T-C EXCLAIM-36H-C Qty.req This page intentionally left blank Warranty For Heat & GLO Fireplaces Limited WarrantyContact Information Do Discardnot