Heat & Glo LifeStyle EXCLAIM-36H-C, EXCLAIM-36T-C owner manual Raised Hearth Extension

Page 26

12in.

(305 mm)

Min.

12in.

(305 mm)

Min.

20 in. (508 mm)

Min.

Note: Maximum height from floor under fireplace to top of finished hearth extension is 7-5/8 in.(195 mm)

 

20 in.

 

(508 mm) Min.

Floor

Hearth Extension

Micore

Hearth Strip

 

Noncombustible Material

Figure 8.4 Raised Hearth Extension

12 in.

 

 

(305 mm)

12 in.

 

Min.

 

 

(305 mm)

30 in. (762 mm)

 

Min.

min.

Figure 8.5 Flush Hearth Extension

Note: Maximum height from floor under fireplace to top of finished heart extension is 7-5/8 in. (194 mm)

Floor

30 in.

 

(762 mm) Min.

 

 

 

 

Hearth Extension

 

Micore

Noncombustible Material

Hearth Strip

 

 

 

26

Heat & Glo • EXCLAIM-36C Woodburning Fireplace • 4013-093 Rev G • 08/06

Image 26
Contents EXCLAIM-36H-C EXCLAIM-36T-C Fire RiskNumber Listing Label Information/LocationGrate Table of Contents Not intended for use as a primary heat source Listing and Code ApprovalsAppliance Certification Negative Pressure Design and Installation ConsiderationsGetting Started Asphyxiation RiskMarginal Location Typical Fireplace System Typical Fireplace SystemFire Risk Explosion Risk Tools and Supplies NeededInspect Fireplace and Components Framing and Clearances Selecting Fireplace LocationClearances Failure to comply may cause fireSidewalls/Surrounds Frame the FireplaceConstruct the Chase Chimney RequirementsFire Risk Sharp Edges Asphyxiation Risk Installation of FireplaceInstall the Outside Air Kit Risk of Smoke SpillageFt min. from top of uppermost chimney section to air inlet Place the Protective Metal Hearth Strips Secure the FireplacePosition the Fireplace Level the FireplaceChimney Assembly Height of Chimney Components Using Offsets/Returns ¨ TableInstall the Ceiling Firestops Assemble the Chimney SectionsSecure the Chimney Install the Attic Insulation ShieldDouble-check the Chimney Assembly Complete the Enclosure Chimney TerminationChase Top Install the Termination CapInstall the Chimney Air Kit required in Canada Installing an ST475 Square Termination Cap Gas Code, Ansi Z223.1 AccessoriesGas Log/Lighter Provisions Finishing Hearth ExtensionRaised Hearth Extension Glass Doors Finishing MaterialMantel Combustible MaterialOperating Instructions General InformationFlue Damper Outside AirClear Space Near the Fireplace FirescreenFirewood GrateWood Fuel MoistureStarting a Fire Troubleshooting Understanding Vent ProblemsSolutions Diagnostics and Problem SolvingDiagnostic Questions Can’t get a good fire going. What am I doing wrong?fireplace burns the wood too fast. What can I do? Disposal of Ashes Maintenance and Servicing the FireplaceChimney Inspection/Cleaning Firebox RefractoryClean Maintenance Task ListWhen cleaning glass door Chimney FireFireplace Dimensions Reference MaterialsFireplace Components Catalog # DescriptionChimney Components Catalog #330 mm 51 mm 14-3/4 375 mm This page intentionally left blank TR442 TR442 / 444 TV Minimum Base Dimensions 28 X 28 with 32 X 32 with 23 XMinimum Base Dimensions 26.5 X 28 with 34 X 34 with 20 xService Parts EXCLAIM-36-C Series Service PartsDescription of Part EXCLAIM-36T-C EXCLAIM-36H-C Qty.req This page intentionally left blank Warranty For Heat & GLO Fireplaces Limited WarrantyContact Information Do Discardnot