Desa TPNPEA-A Optional Wireless hand-held Remote Control Installation, Red White, To Thermopoile

Installation

Continued

You may test the blower for operation by turning the control knob clockwise just until it clicks on which is the full on position. Adjust the fan speed to the lowest setting (this should be no more than 1/4 of a turn clockwise).

For Optional

Fan Kit

From Blower

Assembly

Figure 37 - Connecting Blower

Accessory to Power Supply

OPTIONAL Wireless hand-held REMOTE CONTROL Installation

Note: If using an optional wireless hand-held remote control, the wall switch is no longer operational.

NOTICE: Only use alkaline bat- teries (not included).

Installing HRC100 Model Remote Control (Millivolt Models Only)

1.Remove lower louver access panel in fire- place (see step 1 of Wall Switch Installation, page 21).

2.Disconnect wall switch wires from termi- nals marked TH and TPTH (see Figure 35, page 21).

3.Slide 9-volt battery into clip on back of remote receiver and connect battery terminals to bat- tery. Mount receiver onto bracket with clips provided (see Figure 38).

Plastic Mounting Clips

9-Volt Battery

Gas Receiver Clip

Valve Terminal

Wires

		LOT
ON		16AI
OT		7	TH
L
I
P
FFO	L	HI	TP
	O
E	A		TPTH

Red	White
	FRONT
To Thermopoile

Figure 38 - Installing Remote Receiver

(HRC100)

4.Connect white wire to control valve terminal TH and red wire to TPTH. Move remote select switch to REMOTE position.

5.Replace louvered access panel by following reverse steps on page 21.

6.Remove battery cover on back of hand-held remote (see Figure 39). Remove and discard sensor tag.

7.Attach terminal wires to 9-volt batter. Place battery into housing.

8.Replace battery cover onto hand-held remote.

9.Set selector switch on receiver to OFF posi- tion if you will be away from the unit for an extended period of time.

Battery	Remote Control Unit
Cover
	Sensor
	Tag

Terminal

Wires

Battery

Housing

9-Volt Battery

Figure 39 - Installing Battery in Hand-

Held Remote Control Unit (HRC100)

Installing Skytech/WRC Model Remote Control (Electronic Models Only)

1.Remove lower louver access panel in fire- place (see step 1 of Wall Switch Installation, page 21).

2.If a wall switch was installed, it must be removed from ignition control circuit for remote to work properly. Remove wire nuts from switch connection at ignition control module. Using wire nut, connect transformer (blue) wire to remaining wire connected to control terminal marked P.SW (see Figure 34, page 21).

3.The receiver does not require a battery. To in- stall, plug extension cord into one of the outlet receptacles on the outlet box. Plug receiver unit into extension cord and the ignition module into receiver unit (see Figure 40, page 23).

4.Replace louvered access panel by following reverse steps on page 21.

5.Activate handset battery by removing insulat- ing tab on back (see Figure 41, page 23).

22 www.desatech.com 56131-F