INSTALLATION
Continued
11.Cut an access hole in base to run flexible gas line to fireplace (see Figure 12). Make sure to locate access hole so mantel will cover it when installed. Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.
12.Install gas line. See Connecting To Gas Sup- ply, pages 16 and 17.
13.Check for leaks. See Checking Gas Connec- tions, pages 17 and 18.
14.Place mantel around fireplace. Be careful not to damage wall or mantel.
15.Place perimeter trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap trim over shoulder screws on fire- place (see Figure 12).
16.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for top louver (see Figure 12).
17.Reinstall top louver.
Hole for 3" | Hole for | |
Wood | ||
3" Wood | ||
Screw for | ||
Screw for | ||
Attaching | ||
Attaching | ||
Fireplace to | ||
Fireplace | ||
Wooden | ||
to Mantel | ||
Base | ||
| ||
| Shoulder | |
| Screws | |
Gas Line |
| |
Access |
| |
Hole |
| |
Assembled | Mantel | |
Trim | Base |
Figure 12 - Attaching Perimeter Trim,
Mantel and Base
AssemblingTrim(Trimshippedwithmantel)
1.Remove packaging from three remaining pieces of trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 13.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 13).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 13).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set assembly aside for later installation.
Adjusting Set Screws |
|
Plate | Top |
| |
Slot | Trim |
| Mitered |
Shim | Edge |
|
Side Trim 
Figure 13 - Assembling Trim
INSTALLING OPTIONAL BLOWER ACCESSORY GA3450T
Removing Upper Louver Assembly and Branch Support
To install the blower accessory, you must first re- move the upper louver assembly.
1.Lift screen off fireplace and remove log set if installed.
2.Remove 2 screws from each side of branch sup- port and pull branch support out (see Figure 14).
3.Remove 4 screws from upper louver assembly (see Figure 14). Save these screws.
4.Pull upper louver assembly straight out from the cabinet. Be careful not to scratch the paint. Set louver assembly and screws aside.
5.Open lower louver door by swinging door down (see Figure 12).
Blower Bracket
Mounting Holes
Branch 
Support
Figure 14 - Removing Top Louver and
Branch Support
www.desatech.com | 13 |