Desa VMH26NRB, EFS26NRA, EFS26PRA, VMH26PRB installation manual Gas leak. See Warning

Page 31

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating fireplace where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM POSSIBLE CAUSE

REMEDY

Remote does not function

1. Battery is not install. Battery

 

power is low

1.Replace 9-volt batteries in re- ceiver and remote control

Fireplaceproducesaclicking/tick- ing noise just after burners are lit or shut off

1.Metal expanding while heating or contracting while cooling

1.This is common with most fire- places. If noise is excessive, contact qualified service person

Fireplace produces unwanted 1. Fireplace burning vapors

odorsfrom paint, hair spray, glues, cleaners, chemicals, new car- pet, etc. (See IMPORTANT statement above)

2. Low fuel supply (propane/LP only)

3. Gas leak. See Warning statement at top of page

1.Open window to ventilate room. Stop using odor causing products while fireplace is running

2.Refill supply tank (propane/LP only)

3.Locate and correct all leaks (see Checking Gas Connec- tions, pages 18 and 19)

Fireplace shuts off in use (ODS

1. Not enough fresh air is

1.

Open window and/or door for

operates)

 

available

 

ventilation

 

2.

Low line pressure

2.

Contact local natural or pro-

 

 

 

 

pane/LP gas company

 

3.

ODS/pilot is partially clogged

3.

Clean ODS/pilot (see Cleaning

 

 

 

 

and Maintenance, pages 26

 

 

 

 

and 27)

 

 

 

 

Gas odor even when control knob

1. Gas leak. See Warning

1.

Locate and correct all leaks

is in OFF position

 

statement at top of page

 

(see Checking Gas Connec-

 

 

 

 

tions, pages 18 and 19)

 

2.

Control valve defective

2.

Replace control valve

 

 

 

 

 

Gas odor during combustion

1.

Foreign matter between con-

 

 

trol valve and burner

 

2.

Gas leak. See Warning

 

 

statement at top of page

1.Take apart gas tubing and re- move foreign matter

2.Locate and correct all leaks (see Checking Gas Connec- tions, pages 18 and 19)

113110-01A

www.desatech.com

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents REMOTE-READY Models VMH26PRB, VMH26NRB, EFS26NRA, EFS26PRA Shown with optional cabinet mantel/hearth base accessoryTable of Contents Safety Information Provide adequate clearances around air openings Product IdentificationLocal Codes Optional Remote Control AccessoriesProduct Features AssemblyProviding Adequate Ventilation Assembly AIR for Combustion VentilationUnusually Tight Construction Determining if You Have a Confined or Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Fireplace Location Confined and Unconfined SpaceVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Items InstallationCheck GAS Type Minimum 16 inches from Side Wall BUILT-IN Fireplace InstallationFireplace Clearances Minimum Clearance to Combustible MaterialsRough Opening for Installing Wall Mantel Clearances for Built-In Installation Optional Mantel InstallationRemoving Upper Louver Assembly and Branch Support Installing Optional Blower Accessory GA3450TAssemblingTrimTrimshippedwithmantel Installing Blower Accessory Test to make sure the blower is working properly For Built-In InstallationExtension Cord External Regulator With Vent Pointing Down Connecting to GAS SupplyInstallation Items Needed Connecting Fireplace to GAS SupplyPropane/LP Checking GAS Connections Pressure Testing gas Supply Piping SystemCorrect all leaks at once Installing Receiver Pressure Testing Fireplace Gas ConnectionsOptional Wall Mounted Wire harness provided in the fireplace hard- ware packInstalling 9-Volt Battery in Hand-Held Remote Control Unit Remove battery cover on back of remote con- trol unitInstalling LOG SET and Screen Optional Wall Switch GWMS2Install the base onto the wall with the pro- vided screws Operating Fireplace For Your Safety Read Before LightingSelector Switch OFF Position Control Knob Ignitor Button Flame Adjustment KnobShutting Off Fireplace Manual Lighting ProcedureTo Turn OFF GAS To Appliance Optional HAND-HELD Remote OperationThermostat Series Model Ghrctb ON/OFF Series Model GhrcbOperating Blower Optional GWMS2 Wall Mounted Switch OptionalInspecting Burners GWMT1 Wall Mounted Thermostat OptionalBurner Flame Pattern Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole Air Passageways Wiring DiagramLOG SET CabinetIgnitor cable dry TroubleshootingObserved Problem Possible Cause Remedy Replace pilot assemblyPressed Safety interlock system hasLow gas pressure ODS/pilot assembly Or improperly connected Diagram,Hours of operation Bris. If found, clean burnerResidues from manufactur Tial operationGas leak. See Warning Remote-Ready Models SpecificationsParts Under Warranty Replacement PartsService Hints Technical ServiceIllustrated Parts Breakdown REMOTE-READY Models Parts ListTHERMOSTAT-CONTROLLED Blower KIT GA3450T AccessoriesEquipment Shutoff Valve GA5010 Perimeter Trim KIT GA6095Information Video Receiver and HAND-HELD Thermostat Remote Control KIT GhrctbReceiver and HAND-HELD Remote Control KIT Ghrcb Cabinet Mantel and Full Hearth BasePage Page Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Compact Classic Hearth Fireplace
Top Page Image Contents