INSTALLATION
Continued
8.Reconnect red wire to switch position 3. Re- connect blue wire to switch position 1. Re- connect green and white wires.
9.Install the switch plate on the valve cover shield with 2 #10 screws provided (see Figure 17). Route power cord out of the cabinet by insert- ing it through the bushing on the outer casing (see Figure 15, page 14). Plug fan kit into 120- Volt grounded power supply and test operation. Note: When switch is in the AUTO position, the fan will start after the fireplace has run for a few moments. The fan will continue to run for several moments after the fireplace has been turned off. When switch is in the ON position, the fan will run until turned to OFF. Reinstall upper louver assembly (see Figure 14, page 13) and branch support. Close lower louver door.
Valve Cover
Shield
Switch 
Plate
Screw
Figure 17 - Installing Switch Plate to
Valve Cover Shield
For Built-In Installation
WARNING: A licensed elec- trician must connect the wiring harness to electrical supply fol- lowing all local codes. Electri- cian must provide a clamp on the box cover to secure the wir- ing. Wiring should be routed through the bushing in the hole on the outer casing of fireplace.
1.Install a snap bushing found in hardware kit into one of the holes on rear of valve cover shield. The other hole is for a strain relief clamp (not supplied) to secure incoming elec- trical supply.
2.Follow steps 2 through 6 in Installing Blower Accessory, page 14.
3.A licensed electrician must follow the wiring diagram to connect incoming electrical sup- ply to fan kit wiring harness (see Figure 18).
4.Plug power cord to the outlet receptacle (not provided) as shown in Figure 19. Wind the extra power cord and tie with plastic wire strap (see Figure 19). Set the power cord bundle between the burner bracket and outer casing, away from the burner.
5.Test to make sure the blower is working properly.
6.Reinstall upper louver assembly (see Figure 14, page 13) and close lower louver.
Fan Switch
(Auto/Off/On)
|
| 1 Auto |
|
|
|
|
|
| |||
| Off | 2 |
|
|
|
|
|
|
|
|
|
|
| 3 | Blue |
| Thermostat | ||||||
|
|
| On |
|
|
| Switch | ||||
|
|
|
|
|
| (N.O.) | |||||
110/115 |
|
| Red |
|
|
|
| Blue | |||
V.A.C. |
|
|
|
| Blower | ||||||
| Black |
|
|
|
|
|
|
|
| Motor | |
|
|
|
|
|
|
| Red |
| |||
| White |
|
|
|
|
|
| White |
| ||
| Green |
|
|
|
|
|
| Green | |||
Figure 18 - Wiring Diagram For Blower
Accessory Built-In Installation
Blower | Wire | Clamp | |
Bracket | Connector | ||
Harness | |||
Assembly | (not | ||
| |||
Screw |
| included) | |
|
| ||
Switch | Power Cord |
|
Switch
Plate
Red
Black Blue
Wire Harness | Outlet | |
Receptacle | ||
|
Plastic Wire Strap (not included)
Lower
Louver Door
Figure 19 - Installing Blower Bracket
Assembly
Extension Cord
Use extension cord if needed. The cord must have a
www.desatech.com | 15 |