Operating Fireplace, Lighting Instructions

SUN VALLEY STOVE COMPANY

B-VENT FREESTANDING FIREPLACE

OPERATING

FIREPLACE

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.	This appliance has a pilot which must
	be lighted b y hand . When lighting the
	pilot, follow these instr uctions e xactly.
B.	BEFORE LIGHTING smell all
	around the a ppliance ar ea for gas. Be
	sure to smell ne xt to the floor because
	some g as is hea vier than air and will
	settle on the f loor.
	WHAT TO DO IF YOU SMELL GAS
	• Do not try to light any appliance.

LIGHTING

INSTRUCTIONS

1.STOP! Read the saf ety information in column one.

2.Open lo wer panel.

3.Turn ON/OFF s witch to “OFF”.

4.Turn off all electr ic po wer to the fireplace .

5.Push in g as contr ol knob slightl y and

turn c lockwise to “OFF”.

6.Wait five (5) min utes to c lear out an y gas. Then smell f or g as, inc luding near the f loor. If y ou smell g as, STOP! Follow “B” in the saf ety in- formation in column one . If you don't smell gas, go to the next step.

7.The pilot is located by the main

burner and should not r equir e ac- cessing f or lighting .

8.	Turn knob on g as contr ol counter -
	clockwise	to “PILOT”.
9.	Push in contr ol knob all the w ay and

TO TURN OFF GAS

TO APPLIANCE

1.Open lo wer louv er panel.

2a. Set selector switch in the “OFF” position.

2b. If Using Optional Hand-Held Re- mote: Set selector switch in the OFF position to pr event dr aining ba ttery.

3.Turn off all electr ical po wer to the applianceifser viceistobeperf ormed .

4.Push in g as contr ol knob slightl y and

turn c lockwise to “OFF”.

5.Close lo wer panel.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep the pilot lit by doing one of the following:

1.Turn contr ol knob c lockwise to the PILO T position.

2.SetselectorswitchintheOFFposition.

•	Do not touch any electric switch; do
	not use an y phone in y our b uilding .
•	Immedia tely call y our g as supplier

from a neighbor's phone . Follow the gas supplier's instructions.

C. Use onl y your hand to push in or tur n

the gas contr ol knob . Never use tools.

hold. Immediately light the pilot by

repea tedl y de pressing the piez o

spark ignitor until a flame appears.

Continue to hold f or a bout one (1)

minute after the pilot is lit. Release

knob and it will pop back. Pilot

should r emain lit. If it g oes out, re-

peat steps 5 thr ough 8.

Variable Control Knob

O	H
L	H
	I

Gas Control Knob

T	ON
T
O	OFF
L	OFF
I
P

If the knob will not push in or tur n

by hand , don't tr y to repair it, call a qualified ser vice tec hnician. F orce or attempted r epair ma y result in a f ire or explosion.

D.Do not use this appliance if any part has been under w ater. Immedia tely call a qualif ied ser vice tec hnician to inspect the a ppliance and to r e- place an y par t of the contr ol sys- tem and an y gas contr ol whic h has been under w ater.

	• If knob does not pop up when re-
	leased, stop and immediately call your
	service technician or gas supplier.
	• If the pilot will not sta y lit after se v-
	eral tries, turn the g as contr ol knob
	to “OFF” and call y our ser vice
	technician or g as supplier .
10.	Turn gas contr ol counter clockwise
	to “ON”.
11.	Turn on all electr ic po wer to the
	fireplace .
12.	Turn the ON/OFF s witch to ON
	position.
13.	This v alve is equipped with a HI/LO
	feature. Set f ireplace input as desir ed.
14.	Close lo wer panel.

Piezo Ignitor

Figure 48 - Control Valve

MANUAL LIGHTING

PROCEDURE

1.Remove glass door (see Removing/ Replacing Glass Door, page 16).

2.Follow steps 1 thr ough 8 under Light- ing Instructions.

3.Depress contr ol knob and light pilot with match.

4.Keep contr ol knob pr essed in f or 30 seconds after lighting pilot. After 30 seconds, release contr ol knob . Now follow steps 10 thr ough 14, column 2.

5. Replace glass door (see Removing/ Replacing Glass Door, page 16).

106022