Toshiba MA-186-100 SERIES, EO1-11115 System Option Setting, Programming Procedure, Set @/For

EO1-11115

MA-186-100 SERIES

16. System Option Setting

This operation is provided for your selections of the register’s basic functions according to the market and your requirements.

Programming Procedure

The System Options are divided into 11 addresses (Addresses 1to 16; Addresses 4, 5, 9, 10, and 12 are vacant) and each address is further divided into a maximum of 8 bits (Bits 1 to 8). Each address table is placed on the following pages.

Condition: After Daily Financial Reset (refer to “NOTE on Codition” on page 15)

Programming Procedure:

Use the MA Key to turn the Control Lock to “SET”.

X

REG
OFF	Z	→ 1 8 →
SET

@/FOR

Repeat for Bit status changes in all the required Addresses.

→	ST	→			#/CID	→
→
Address No. (max. 2			Bit Nos. that are set to “SET” status	( or		)
digits; 1 to 16)			(max. 8 Bit Nos. combination of 1 to 8)		#/NS

AT/TL

Enter a maximum of eight-digit number composed of Bit Nos. whose status must be set to the “SET” status in the Address. If there is no Bit No. to be set to the “SET” status, enter “0” for the Address.

Examples) To set Bit 2 only	Enter 2.
To set Bits 2 and 3	Enter 23.
To set all the Bits	Enter 12345678.
To reset all the Bits	Enter 0.

To change any Bit in an address, enter the Address No. and enter all the SET Bit Nos. again. If a Bit No. is not included in the SET Bit Nos., the Bit will be RESET.

- 69 -