Toshiba EO1-11115 Void Designated Line Voiding, Repeat entry is not possible using the Void key

EO1-11115 MA-186-100 SERIES

Void (Designated Line Voiding)

VOID

(Void Key)

A Department or PLU item entered before the last item but canceled in the current sale (which can no longer be deleted by [ITEM CORR]) is entered as a Void item using the [VOID] key. If this key is not installed on your register, the [RTN MDSE] key may be used for voiding purposes (refer to the next page). If both [VOID] and [RTN MDSE] are installed, [VOID] should be used to cancel (delete) an item already entered within the current transaction while [RTN MDSE] should be used to record an item that was purchased in a past sale and is now returned.

Depress VOID prior to or any time during the entry

sequence of the following operations:

Entry of One Department Item Other Income Department Department Quantity Extension Department SPP Single-item Department Entry Entry of One PLU Item

PLU Quantity Extension Single-item PLU Entry

Percent Discount/Charge on a Department or PLU Item (NOTE 1)

(Repeat entry is not possible using the [VOID] key.)

0 1 ★6.0 0 VD

←

“VD” ... Symbol of Void item

NOTES: 1. When an item previously entered with a Percent Discount or Percent Charge is canceled, the item can be voided with the Percent Discount/Charge by attaching the [VOID] key to the same entry procedure as previous entry.

At Entry

0 1 ★6.0 0

5.

-0.3 0

TM

% -

At Void
0 1	★6.0 0
5.	★0.3 0

VD

% -

The process of the amount

resulted from % calculation

is reversed at Void.

2.The Void entries are usually possible only inside a sale. However, when the option “Credit Balance Allowed” is selected, they are allowed outside a sale as well and over-subtraction of the sale is also allowed. (Refer to Chapter “16. System Option Setting”, Address 2 - Bit 3 on page 72.)

3.Neither Negative Department nor Negative PLU items can be entered as Void items.

- 50 -