Toshiba EO1-11115, MA-186-100 SERIES owner manual Department LC Listing Capacity Programming, 01.1

EO1-11115

MA-186-100 SERIES

Department LC (Listing Capacity) Programming:

The LC setting is used to check an amount limit error. By setting the LC, an amount entry (due perhaps to a mistake by the operator) will be prevented at the earliest stage (i.e., an error will result on entering an excessive amount through the department key).

Condition: After Daily Financial Reset (refer to “NOTE on Condition” on page 15)

Programming Procedure:

Use the MA Key to turn the Control Lock to “SET” .

X

REG

OFF Z →

8

→

@/FOR

SET Declaration of Program No. 8 for Department LC programming

→ →

Repeat for setting LCs of other departments.

To designate the

Department

Nos. 21 to 40.

→ ( SHIFTDPT ) → Dept. →

2-digit LC code for

each department NOTES 1, 2

→ AT/TL

Common 2-digit LC code for

all departments NOTES 1, 2

ex.)

3

4	..........	indicates $ 39.99	Allows to enter equal to or smaller than
			$39.99 in sale entries.
		4 digits
Value of the top digit

NOTES: 1. If the individual LC of a department is set, it prevails over the common LC for all departments.

2.To reset a LC once set, enter “0” in place of the 2-digit LC code. Then a maximum of 7-digit amount can be entered in sale entries.

Department LC Program Receipt Format:

Key Operation

Control Lock: SET

8 @/FOR

7	3	Dept. 1
9	4	Dept. 2
5	4	Dept. 3

0 Dept. 4

8 6 AT/TL

	Thank you
	Call again	Listing Capacity Code
05.- 28.- 9 7			Top digit value
			Number of
0.8 ★
			maximum digits
0 1	7 3
0 2	9 4	for each department
0 3	5 7
0 4	0 0
	8 6		Common LC for all departments

001.1

08 - 5 2

- 35 -