Toshiba MA-186-100 SERIES, EO1-11115 instruction

EO1-11115

MA-186-100 SERIES

20. Paper Roll Replacement and Other Maintenance

Replacing the Paper Roll (When used for receipt)

When a red line appears on the edge of the paper roll, follow the steps below to replace the paper roll with a new one.

WARNING!

Care must be taken not to injure yourself with the paper cutter.

REG	X	1
REG		1
OFF	Z	Turn the Control Lock to the REG position
		using the Control Key.
SET

2

To remove the Printer Cover, insert the

Printer Cover Key to the Printer Cover

Lock, and then turn it 90° clockwise.

3

Cut the paper as shown in the figure.

- 90 -

Image 96

Toshiba MA-186-100 SERIES Paper Roll Replacement and Other Maintenance, Replacing the Paper Roll When used for receipt

Contents

MA-186-100 Series Page Safety Summary Meanings of Each SymbolSafety Summary Precaution Table of Contents Toshiba TEC Introduction Unpacking Outline of Preparation Procedure Before Operating REGOffz SET REG Offz SET Appearance and Nomenclature Control Lock and Control Keys Control KeysControl Lock REG Key Display Operator’s DisplayCustomer’s Display Numeric Display Message Descriptors Triangular LampsALM OFF Keyboard Other Optional KeysStandard Keyboard Layout CID Installing the Paper Roll REG OFF Duplicate Sheet Original Sheet EO1-11115 MA-186-100 Series Time and Date Setting Time Setting or Adjustment Date Setting or Adjustment REG OFF @/FOR AT/TL SETDate now set 04.- 15.- 9 05.- 28.- 9 00.9 Tax Table Setting Displaying the TimePrinting the Time and Date Setting Procedure Setting Examples To indicate that no breaks are enteredA single-tax area, the TX1/M key may be labeled as TX/M key Ex Tax 1 Full Breaks Ex Tax 1 a Break and % Rate Combination Ex Tax 1 % Rate only05.- 28.- 9 01.7 05.- 28.- 9 10. % 01.8 GST/M Thank you01.5 Non-taxable Limit Amount Setting 05.- 28.- 9 20.0 02.4Tax 1 memory Taxable Limit Amount programmed Optional Key Setting Operating ProcedureTax Calculation Test List of Keys Receipt Issue Post-receipt Department Keys 1 to Key Installation Setting REG OFF AT/TL SET BlindRefer to the List Keys on the pre Ceding For the Standard Keyboard Layout Refer to Chapter That the setting operation is completed. No printing occurs Plan before starting the setting procedureIssue without entering numbers Receipt Issue Post-receipt Key Daily Operation Flow Before Opening the StoreDuring Business Hours After Closing the Store Entries in Training Mode Training Setting Preparation of Each Key and Transaction Entries Receipt-issue/Non-issue Selection41.3 41.4 Combination of 6 + No-sale Exchange VoidThank you ← 10.2 Received-on-Account Payment 12.5 10.3 Paid Out Department KeysProgramming Department Keys 10.4 Programming Procedure Department Status Programming DP Amount Be entered within one sale receipt sequencePayment of electricity and gas, and donation Department Status Program Receipt Format TX1/M TX2/M00.5 Department LC Listing Capacity Programming Department LC Program Receipt Format01.1 Department Preset Price Setting Department Preset Price Setting Receipt FormatLast setting is effective 05.- 28.- 9 34.5 02.0 Sale Item Entries Using Department Keys Entry of One ItemRepeat Entry Quantity Extension Multiplication RepeatItem of the Department Nos to Split-Package-Pricing Department SPP PLU Price-Look-Up PLU Key Single-item Department EntryOther Income Department Entry 10.0 10.5 Programming PLUs PLU Table Setting Dept Deleting Individual PLUs PLU Table Program Receipt FormatAMT PLU Preset Price Changing PLU Deletion Receipt Format05.- 28.- 9 00.7 OFF PLU #/CID PLU Price Change Setting Receipt Format Sale Item Entries of PLUsPL01.1 23.4 02.1 @/FOR AMT 40.0 Listing Capacity Open Percent Charge, Percent DiscountSingle-item PLU Entry 28.- 9 PL10.1 10.7 Key Preset Rate Setting or Changing 05.- 28.- 9 10. % + 01.305.- 28.- 9 01.4 Key Operations in Sale Entries 6.015.0 Dollar Discount Item Correct Last Line Voiding Repeat entry is not possible using the Void key Void Designated Line Voiding All Void Transaction Cancel Returned Merchandise18.7 Non-add Number Print SET #/CID23.0 0 0 # Subtotal Read Taxable Total Read22.9 Manual Tax Entry Finalizing a SaleTAX Media Total Post-issue Receipt Check Cashing Cashing Non-cash Media11.8 Bit 3 on Tax Status Modification TX/MPercent Charge Percent Discount Tax Exemption To exempt the sale from designated taxesTo exempt the sale from all taxes Print/Non-print Options on Sale Receipts Tax / PST and GSTTax / PST Read and Reset Reports Programming Operations Relating to ReportsProgramming Hourly Range Table Refer to Note on Condition on Selecting Print/Non-print Items on Reports Programming Example05.- 28.- 9 01.0 Taking Read and Reset Reports Fundamental Concepts of Various Types of ReportsReport Taking Operation Daily Reports Periodical ReportsReport Sample Format Report Name Key Operation Financial Read or Reset Report Daily or Periodical 05.705.7 42.7 31.0 12.0 75.5 10.0 14.0 00.020.7 Memory Balance Grand TotalGross Sale Net Sale with Tax Daily Hourly Sales Read or Reset Report Daily PLU Read or Reset Report All or ZoneDaily All PLU Read or Reset Report Thank you Call again Daily Zone PLU Read or Reset Report Cashier Read or Reset Report Daily or Periodical Daily Cashier Read or Reset Report Thank you Call againDaily Media Sales & In-drawer Read Report Daily Individual Department Read Report 33.405.0 10.0 00.0 10.0 67.1 32.2 System Option Setting Programming ProcedureSET @/FOR Address 1 refer to the next 05.- 28.- 9 01.2 Address Non-print OptionsYour Selection → Vacant Optional Functions Disc or Void keySupplementary Description for Address Register. Refer to on page 82 for Tax Status Vacant Supplementary Description for AddressAddresses 4, 5 are vacant AT/TL Key Function Total CHK TND Key Function Bit Content Selective Status Vacant Cashing with no purchase, using this keyOver-tendering tendering an amount larger than the sale Reset Chg Key FunctionProhibited Allowed Prohibited Address 1 TL, CHK TND, ChgAddress 12 is vacant Separate Line Print Lines Initial SET Bit Nos Your SelectionGST Options ... for Canada Resettable SubtotalTaxable Total ANY Number Only Once Times Cashier Signing Operation optional function Programming RequirementsCashier Sign on & Sign OFF 10.1 Near-Full Warning in REG Mode Electronic Journal E.J. Print optional functionCashier Reports Programming Requirement Reading of the Remaining Lines of E.J. Memory Electronic Journal ReportOperation OFF SET 10.1 10.2 PL20.0 10.0 18.7 12.732.0 Operating Procedure Program Data Verification Department Preset Price Read Department LC and Status Read66.6 01.7 PLU Table Read Other Programmed Data Read System Option Read 02.2 Paper Roll Replacement and Other Maintenance Replacing the Paper Roll When used for receipt Replacing the Paper Roll When used for journal EO1-11115 MA-186-100 Series Replacing the Ink Ribbon REG7 Offz SET Replenishing Ink to the Store Name Stamp Allow time for ink to saturate the stamp Manual Drawer Release and Lock Battery Exchange Removing the Drawer Changing the Layout of the Money Case Media Slot Case of the Power Failure TroubleshootingTrouble concerning Power Supply Power is not turned on Been selected. . System Option Setting, Address 2 Bit 7 on Paper roll wrinkles Printer prints nothingPrinting as a whole is too light Printing gets stained Trouble concerning Drawer Drawer does not open Trouble concerning Display Display displays nothingTrouble during Normal Operations Normal operations cannot be carried out Error tone beeps Setting, Address 16 Bit 1 onSystem Option Setting, Address 2 Bit 8 on Bit 1 on Operating Procedure Status Clear and Memory Clear OperationsStatus Clear 27.1 Sales Memory Clear OperationX05.- 28.- 9 00.1 An All Memory Clear receipt is issued All Memory Clear Specifications Size of Paper RollAmount and Counter Totals in Report Memory Specifications are subject to change without notice Memory Protection Date Company Name Address City Country Your Name Phone ZIP CodeToshiba TEC Model MA-186-100 Unit Price QTY Amount Stamp EO1-11115 MA-186-100 Series Page Page TEC