Installation
PLATED TRIM INSTALLATION:
TO AVOID PERSONAL INJURY DO NOT REMOVE OR REPLACE TRIMS WHEN PELLET STOVE IS HOT!
KIT COMPONENTS:
Quantity | Description |
|
|
2 | Upper Cabinet Trim |
|
|
2 | Lower Cabinet Trim |
|
|
1 | Top Trim |
|
|
3 | Louver |
|
|
4 | #8 nut plated (spares) |
|
|
TOOLS REQUIRED:
●
Upper
Cabinet Trim
Lower
Cabinet Trim
#8 Hex Nut (x8) 
Left Cabinet
Side
#8 Stud (x8)
Figure 43: Right cab side with upper and lower cabinet trims.
REMOVAL OF SIDE TRIMS:
When stove is off and cool, open the door. Remove the two (2) screws on the right cab side (at top and bottom of front flange) and the two (2) screws on the left cab side (one above and one below hinge). The cab sides have hinges at the back so they can swing open when the screws have been removed.
Remove the trims that will be replaced by unfastening the #8 hex nuts (four (4) for each piece of trim) by hand. Carefully remove the trim from the studs.
REPLACEMENT OF SIDE TRIMS: | Top Front | |
| ||
Place the new trim pieces on their corresponding studs |
| |
and finger tighten the #8 hex nuts (four (4) for each |
| |
piece of trim). Refer to Figure 43. |
| |
Close both cab sides and replace the two (2) screws on | #8 Stud (x6) | |
each side. | Top Trim | |
REMOVAL OF TOP TRIM: |
| |
With door open, undo the two (2) screws on the | #8 Hex Nut (x6) | |
underside of the top there are visible under the angled | ||
corners. Open the hopper lid, remove the two (2) screws | Hand Tighten Only | |
Figure 44: Top front with top trim | ||
that are found attached to the top under the hopper lid. | ||
|
Pull top forward, lift the top front piece off the stove and turn it over. Remove the six (6) #8 hex nuts and pull the trim off the studs.
REPLACEMENT OF THE TOP TRIM:
Place the new trim on its corresponding studs (see Figure 44) and finger tighten the six (6) #8 hex nuts.
Replace top front on top of the stove, remembering to hook the two (2) front tabs under the corresponding tabs on the stove. Replace the two (2) screws on the top under the hopper lid then close lid. Replace the
30