Weber 3400 Series owner manual Continue frame assembly, Complete frame assembly

Page 12

Step 4

Continue frame assembly

You will need: frame assembly, wheel frame assembly, front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. The fuel scale decal should face away as shown. Figure 3.

The leg tabs must be on the inside of the frames.

Add front panel with the hole down and to your right. Add the washers to the bolts, insert in the holes as shown. Only start the bolts at the wheel frame, figure 3 (a) & (b), and tighten the bolts at the caster frame.

Note - Fuel scale decal on wheel frame must be on the same side as the front panel.

Step 5

Complete frame assembly

You will need: partial frame assembly, one frame connector with bushings, one frame connector without bushings, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench.

Hold the frame connector, bushing side down, between the caster and wheel frame, above the front panel. Add nylon washers to the bolts, put the bolts through the frame and screw into the frame connector. Tighten.

The second frame connector has no bushings, place it between the caster frame and the wheel frame. Add a nylon washer to the bolt, put the bolts through the frame and screw into the frame connector. Tighten. Figure 4.

Caster frame

Dimples to the inside

Wheel frame

Fuel scale decal

Bushings down

Figure 4

Only start

this bolt

Figure 3

12

Image 12
Contents Platinum 3400 Series LP GAS Units only Warranty Patents and Trademarks Contents For Installation in Canada General InstructionsStorage Operating areaAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyCheck the frame assembly Install left end panelInsert casters Install the three back panels Install side burner locksAdd cooking box Install side burner Install manifold bracketMWARNING Make sure gas supply is OFF Install tank panel assembly Install right end panelInstall igniter Install bottom accessory traysAdd fuel scale Install left hand swing table Check that all burner valves are offInstall right hand swing table Hinge rod View from rear of barbecue MCAUTION Do not remove adjustment wing nut from tank scale Set LP fuel scaleFill LP tank Connect LP tankCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall Flavorizer Bars and Cooking Grates Install the bottom tray Install the lidSecure the side burner MCAUTION Make sure both locks have snapped into placeInstall glass doors Complete accessory installationLighting To ExtinguishManual Lighting Lighting the side burner Lighting only the side burner. FigurePeriodic Cleaning CookingStorage and/or Nonuse Storage and/or NonuseConnecting the filled LP tank Refilling the LP tankRemoval of the LP tank Engaged Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Page Burner does not light, or flame is low in High position NCAUTION Do not line the bottom tray with aluminum foilSide Burner Troubleshooting Side Burner MaintenanceFlame is low in High position 15-16 18-20 Parts List NWARNING Use only Weber factoryAuthorized parts. The use of any part that is Final Word Thanks