Weber 3400 Series owner manual Lighting the side burner, Lighting only the side burner. Figure

Page 30

Lighting the side burner

The side burner has a separate ignition system from the main cooking box.

mDANGER

Failure to open lid while igniting the side burner, or not waiting 5 minutes to allow gas to clear if the side burner does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

Lighting only the side burner. Figure 3.

1)Open the side burner lid.

2)Check that the fuel scale reads more than “E”.

3)Check that the side burner valve is OFF (push down and turn clockwise), and all main burner control valves are OFF (push down and turn clockwise).

4)Turn the LP tank valve on (turn counterclockwise).

5)Push down and turn the side burner control valve to HI.

6)Push the side burner igniter button several times so it clicks each time.

1

5

3

6

Figure 3

mCAUTION: Side burner flame may be difficult to see on a bright sunny day.

mWARNING: If the side burner does not light:

a)Turn OFF the side burner control valve.

b)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

Lighting the side burner if the main burners are lit. Figure 4.

1)Open the side burner lid.

2)Push down and turn the side burner control to HI.

3)Press the side burner igniter button several times so it clicks each time.

1

2

3

Figure 4

mCAUTION: Side burner flame may be difficult to see on a bright sunny day.

mWARNING: If the side burner does not light:

a)Turn OFF the side burner control valve.

b)Wait 5 minutes to let the gas clear before you try again or try to light with a match.

30

Image 30
Contents Platinum 3400 Series LP GAS Units only Warranty Patents and Trademarks Contents Storage For Installation in CanadaGeneral Instructions Operating areaAssembly Check package contentsStep Page Page Check contents of hardware packs Assemble wheels Assemble frameContinue frame assembly Complete frame assemblyCheck the frame assembly Install left end panelInsert casters Install the three back panels Install side burner locksAdd cooking box Install side burner Install manifold bracketMWARNING Make sure gas supply is OFF Install tank panel assembly Install right end panelInstall igniter Install bottom accessory traysAdd fuel scale Install left hand swing table Check that all burner valves are offInstall right hand swing table Hinge rod View from rear of barbecue Fill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Connect LP tankCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall Flavorizer Bars and Cooking Grates Install the bottom tray Install the lidSecure the side burner MCAUTION Make sure both locks have snapped into placeInstall glass doors Complete accessory installationLighting To ExtinguishManual Lighting Lighting the side burner Lighting only the side burner. FigureStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseConnecting the filled LP tank Refilling the LP tankRemoval of the LP tank Engaged Safe handling tips for LP Gas Liquid Propane LP TanksAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsMCAUTION Do not enlarge the burner ports when cleaning General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Page Burner does not light, or flame is low in High position NCAUTION Do not line the bottom tray with aluminum foilSide Burner Troubleshooting Side Burner MaintenanceFlame is low in High position 15-16 18-20 Parts List NWARNING Use only Weber factoryAuthorized parts. The use of any part that is Final Word Thanks