Weber 3400 Series Check for gas leaks, MWARNING Do not ignite burners while leak checking

Page 23

The hose and regulator are connected in the following manner:

Slide back the collar of the quick disconnect on the tank valve. Push the male fitting of the regulator into the quick disconnect, and maintain pressure. Slide the collar closed. Figure 32 (a). Figure 32 (b) shows the quick disconnect engaged and various components of the tank and regulator. Regulator vent hole should be at 3, 6, or 9 o'clock. It should not be pointed up. Figure 32 (c).

Step 25

Check for gas leaks

mDANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property.

(a)

Male fitting

Hose (b)

Tank valve

Regulator

Regulator vent

Collar

Valve handwheel close clockwise

Pressure relief valve

Tank

mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note - All factory made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may have loosened or damaged a gas fitting.

mWARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution and a rag or brush to apply it.

Note - Since some leaks test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Make sure side burner is OFF. Remove valve control knob and screws. Remove porcelain top. Figure 33.

Quick disconnect engaged

(c)

Turn so regulator vent does not collect water

Figure 32

Figure 33

To perform leak checks: open tank valve by turning the tank valve handwheel counterclockwise. Figure 34.

E

F

Figure 34

mWARNING: Do not ignite burners while leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak.

23

Image 23
Contents Platinum 3400 Series LP GAS Units only Warranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Check the frame assemblyInstall left end panel Install side burner locks Install the three back panelsAdd cooking box MWARNING Make sure gas supply is OFF Install side burnerInstall manifold bracket Install right end panel Install tank panel assemblyAdd fuel scale Install igniterInstall bottom accessory trays Check that all burner valves are off Install left hand swing tableInstall right hand swing table Hinge rod View from rear of barbecue Connect LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Fill LP tankMWARNING Do not ignite burners while leak checking Check for gas leaksInstall Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure the side burnerComplete accessory installation Install glass doorsTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRemoval of the LP tank Connecting the filled LP tankRefilling the LP tank Engaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Page NCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionFlame is low in High position Side Burner TroubleshootingSide Burner Maintenance 15-16 18-20 Authorized parts. The use of any part that is Parts ListNWARNING Use only Weber factory Final Word Thanks