Step 22
Set LP fuel scale
You will need: LP tank (empty).
Note - For accuracy, the fuel scale must be set with an empty tank.
We utilize various LP tank manufacturers. Some of the tanks we receive have differing top collar assemblies. (The top collar is the metal protective ring around the valve.) One series of tanks mounts with the valve facing the rear. The other tanks mount with the valve facing away from the fuel scale. These types of tanks are illustrated in Figure 30.
Loosen the tank lock wing nut. Tighten so the lock is held up out of the way. Figure 30 (a). Lift and hook the tank onto the fuel scale. With an empty LP tank, adjust the fuel scale setting to E by turning the scale setting (top) wing nut. Figure 30 (b).
mCAUTION: Do not remove adjustment wing nut from tank scale.
After adjusting tank scale, push tank down a couple of times to check that the tank scale is set on “E”.
To fill, take the LP tank and filler adapter to an RV center or look up
mWARNING: We recommend that your LP tank be filled at an authorized LP gas dealer by a qualified attendant, who fills the tank by weight.
IMPROPER FILLING IS DANGEROUS.
Tell your LP dealer that this is a new LP tank. The air must be removed from a new LP tank before the initial filling. Your LP gas dealer is equipped to do this.
The LP tank must be installed, transported and stored in an upright position. LP tank should not be dropped or handled roughly.
Never store or transport the LP tank where temperatures can reach 125° Fahrenheit (too hot to hold by hand – for example: do not leave the LP tank in a car on a hot day).
mCAUTION: When transporting the LP tank make sure the plastic dust cover is in place. This will keep dust and dirt from the threaded portion of the valve.
For full instructions for safe handling of LP tanks see section "Operating Instructions".
mWARNING: If you exchange your LP tank, make sure you get a similar tank in return. Your LP tank is equipped with a
Tank lock wing nut
(a)
E | E |
F | F |
|
Figure 30
Step 23
Fill LP tank
Scale setting | Step 24 |
| |
wing nut | Connect LP tank |
mWARNING: Make sure that the LP tank valve is
(b)closed. Close by turning clockwise.
Hook the LP tank onto the fuel scale. Loosen the tank lock wing nut. Swing the tank lock down. Tighten the wing nut. Figure 31.
E | Tank lock |
| wing nut |
F |
|
Note - The LP tank manufacturer is responsible for the | Figure 31 |
materials, workmanship and performance of the tank. If |
|
the tank has a defect, malfunctions, or you have a |
|
question regarding the tank, call the tank manufacturer's |
|
customer service center. The phone number is on the |
|
warning decal which is permanently attached to the tank. |
|
If the tank manufacturer has not resolved the issue to your |
|
satisfaction, then call your dealer. |
|
22