Weber 3400 Series owner manual Check that all burner valves are off, Install left hand swing table

Step 19

Check that all burner valves are off

You will need: one burner control knob.

(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off, proceed to the next step. Figure 21.

Figure 21

Step 20

Install left hand swing table

You will need: swing table end bracket, two 10-24 hex nuts, two 10-24 x 1 3/4 inch machine screws, left hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers.

Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 22 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 22 (b). The rod should swing freely inside the locking tab. Figure 22 (c).

Insert one end of the hinge rod into the hole in the frame. Figure 23 (a).

Insert the other end into the hole in the swing table end bracket. Figure 23 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 23 (c).

To fully seat the bracket, you may have to tap it lightly with a hammer.

mWARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call your dealer to order a new part.

mWARNING: The load limit for the swing table is 30 pounds.

Hinge rod

(a)

(b)

View from rear

of barbecue

(c)

(b) (c) Figure 23

Support rod

	Slot in frame
(a)	(view from below)

Figure 22

19