Step 9
Install the three back panels
You will need: frame assembly, two plastic buttons and the three back panels. (Number 2)
Place the bottom of one back panel on the back frame connector, notches to the top. Set in place to the far left, butting up against the caster frame. Repeat the procedure with the the other two back panels. Figure 8.
Figure 8
Step 10
Install side burner locks
You will need: frame assembly, two side burner locks and a 7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side burner lock. The “U” shape cut out of the lock slips down over the bolt. Tighten with a wrench. Figure 10 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock fits between the front panel and the frame. The “U” shape cut out slips up over the bolt. Tighten with a wrench. Figure 10 (b).
With all three panels in place and flush with each other,
push in the plastic buttons. They should cover the flangesFigure 10 of the panels up against the wheel and caster frames.
Figure 9.
Caster frame
Figure 9
14