Weber 3400 Series owner manual Install glass doors, Complete accessory installation

Step 31

Install glass doors

You will need: one LH glass door assembly and two RH glass door assemblies.

Start with the LH door assembly. Insert the long hinge pin at the top of the door into the plastic bushing in the underside of the left frame. Insert the bottom (short) hinge pin into the bushing in the frame connector. Repeat the procedure with the RH door assemblies. The glass doors latch on the frame connector. Figure 44.

Bushing in underside and long hinge pin

Bushing in frame connector and short hinge pin

Bushing in the underside

Figure 44

Step 32

Complete accessory installation

You will need: work table, Warm-Up Basket, warming rack, thermometer, two tubing plugs and a hammer.

Insert one end of the Weber Warm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid. Figure 45 (a).

Set the work table onto the left side rails. Figure 45 (b).

Set the warming rack into the slots at the rear of the cooking box. Figure 45 (c).

Insert the thermometer into its holder. Figure 45 (d).

Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 45 (e).

(a)

(d)

(b)

(c)

(e)

Figure 45

mCAUTION: To keep the barbecue stationary, the tabs on the locking casters should be in the down position.

27