Weber 3400 Series owner manual Add cooking box

Step 11

Add cooking box

You will need: frame assembly, cooking box assembly, spacer bracket, 1/4-20 x 2 inch bolt, nylon washer, 1/4-20 keps nut, pliers and a 7/16 inch wrench.

Uncoil the hose.

Set the cooking box into the frame so the burner tubes are under the frame brace. Figure 11.

Burner tubes

Frame brace

Figure 11

Slide the cooking box to the left within the frame. Put the washer on the bolt. Take the spacer bracket and hold it up to the frame making sure both tabs fit underneath the frame cross piece. Figure 12 (a). Insert the bolt through the center hole in the spacer bracket, frame and cooking box with the head of the bolt outside the spacer bracket. Figure 12 (b). Add the keps nut. Figure 12. Tighten by holding the bolt with pliers while you tighten the nut with a wrench.

Frame cross piece

(a)

Spacer bracket

Keps nut

(b)

Bolt

Nylon washer

Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment:

a)Do the valves fit into the ends of the burners? Figure 13 (a).

b)Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 13 (b).

c)Are the wing nuts under the burner assembly hand tight? Do not tighten with pliers. Figure 13 (c).

If you answered YES to a, b and c, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact your dealer. Do not use your barbecue.

Guide screw

(b)

(a)

(c)

Figure 13

Wing nuts

Figure 12

15