Weber 3400 Series owner manual Install tank panel assembly, Install right end panel

Page 17

Hose and regulator

Step 14

Install tank panel assembly

You will need: tank panel assembly.

Slide the side burner back. Insert the tabs into the slots in the frame brace at the wheel legs. (Make sure the side burner hose is to the front of the barbecue.) Figure 16 (a). Slide up until the notch at the bottom of the tank panel fits over the cross brace. Figure 16 (b).

Slot in frame brace

(a)

Frame brace

		Tabs on tank panel
	Side burner	(b)
	hose	(b)
	hose

Figure 16

Cross brace

Step 15

Install right end panel

You will need: right end panel (Number 3), 1/4-20 x

1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers and a 7/16 inch wrench.

Set the right end panel in place with the flange at the top facing away from the barbecue, and the bottom flange under the frame brace. Figure 17.

Make sure the gas supply hose is on the outside of the panel. Put washer on bolt and insert bolt through both panels and frame brace. Add washer and hex nut and tighten. Figure 17.

Side burner hose

Figure 17

17

Image 17

Contents Platinum 3400 Series LP GAS Units only Warranty Patents and Trademarks Contents General Instructions For Installation in CanadaStorage Operating areaStep AssemblyCheck package contents Page Page Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Check the frame assemblyInstall left end panel Install side burner locks Install the three back panelsAdd cooking box MWARNING Make sure gas supply is OFF Install side burnerInstall manifold bracket Install right end panel Install tank panel assemblyAdd fuel scale Install igniterInstall bottom accessory trays Check that all burner valves are off Install left hand swing tableInstall right hand swing table Hinge rod View from rear of barbecue Set LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tankMWARNING Do not ignite burners while leak checking Check for gas leaksInstall Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure the side burnerComplete accessory installation Install glass doorsTo Extinguish LightingManual Lighting Lighting only the side burner. Figure Lighting the side burnerCooking Periodic CleaningStorage and/or Nonuse Storage and/or NonuseRemoval of the LP tank Connecting the filled LP tankRefilling the LP tank Engaged Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Page NCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionFlame is low in High position Side Burner TroubleshootingSide Burner Maintenance 15-16 18-20 Authorized parts. The use of any part that is Parts ListNWARNING Use only Weber factory Final Word Thanks