Weber 3400 Series owner manual Add fuel scale, Install igniter, Install bottom accessory trays

Step 16

Add fuel scale

You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers.

Insert indicator rod of fuel scale through the elongated hole in the right end panel. Figure 18 (a).

Slip the bolts on the back of the fuel scale assembly through the two small holes in the right end panel and tank panel. Add washers, then wing nuts and tighten. Figure 18 (b).

Step 18

Install igniter

Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.

The igniter lock nut is on the igniter.

Route the igniter and wires as shown. Figure 20 (a). Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 20 (b). Loosen the igniter lock nut and slide the igniter to the rear of the keyhole. Figure 20 (c). Tighten the igniter lock nut.

Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.

(b)	(a)
	E
	E
	F
	F
View from front left	View from front right

Figure 18

Step 17

Install bottom accessory trays

You will need: two accessory trays

Set the two accessory trays between the two frame connectors. Figure 19.

(a)

(b)

(c)

Keyhole in	Igniter
	lock nut
frame brace

Frame brace	Small part of
	keyhole in
	frame brace
	Figure 20

Figure 19

18