Regency U39-NG1, U39-LP1 LOG Replacement, Door Gasket, Latch Adjustment, Glass Replacement

MAINTENANCE

LOG REPLACEMENT

The unit should never be used with broken logs. Turn off the gas valve and allow the unit to cool before opening door to carefully remove the logs. The pilot light generates enough heat to burn someone. If for any reason a log should need replacement, you must use the proper replacement log. The position of these logs must be as shown in the diagram under Log Installation.

Note: Improper positioning of logs may create carbon build-up and will alter the unit’s performance which is not covered under warranty.

DOOR GASKET

If the door gasket requires replacement use 7/8" diameter oval door gasket (Part # 650-920).

LATCH ADJUSTMENT

The door latch may require adjustment as the doorgasketmaterialcompressesafterafewfires and after glass replacement.Turn the adjustable catch to tighten or loosen the latch.

GLASS

REPLACEMENT

Your ULTIMATE stove is supplied with high temperature,5mmNeoceramceramicglassthat will withstand the highest heat that your unit will produce. In the event that you break your glass byimpact,purchaseyourreplacementdoorfrom an authorized Regency® dealer only, and follow our step-by-step instructions for replacement. The glass is not sold separately, as it must be properly sealed in the door frame.

Replacement Part #

940-325/P U39 Wraparound Glass

940-322/P U39 Panel Center Glass

940-323/P U39 Panel Side Glass

WARNING:Donotoperateappliance withglasspanelsremoved,cracked orbroken.Replacementoftheglass should be done by a licensed or qualified service person.

Note: Wearing gloves will protect your hands while handling glass.

Panel Glass Replacement

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Pull out the door gasket.

3)Remove the nuts holding the glass retainers in place.

4)Remove the glass retainers (sides, top and bottom) and the door catch plate.

5)Replace the glass. The glass must have gasketing around it.

6)Reverse the previous steps, replace the retainers and fasten with the nuts but do not overtighten, as this can break the glass. Note: the door catch plate fi ts on top of the left side retainer.

7)Put gasket glue on the retainers, but do not put glue on the screws. Replace the door gasket, the two ends butt tight together on the bottom edge of the door.

8)Replace door on the stove and check the seal.

Panel Glass Door Assembly

Wraparound Assembly Door (same glass retainers as the Panel Assembly)

Mitred Glass Replacement

Removing Glass

1)Remove the door from the unit and place on a soft surface to prevent scratching.

2)Pull out the door gasket.

3)Remove the 24 nuts holding the glass retainers in place. Do not remove the nuts underneath the retainers.

4)Remove the door catch plate.

5)Removeglassretainersonsidesfirst(3each side) then remove two center retainers.

Note: Center glass retainers are glued to center glass.

6)Remove glass from extrusions. When removing center glass, leave white insulation in place.

Installing Glass

1) Install both center and side glass onto extrusions as per diagram.

2)Place glass assembly into door frame.

3)Install retainers by placing 1 drop of glue where previously glued and put in place.

4)Install side retainers.

5)Install door catch plate.

6)Install the 24 nuts loosely, do not tighten yet.

Regency® U39 ULTIMATE Direct Vent Freestanding Gas Stove 37