Nilfisk-ALTO 692003 manual LOW Solution Light, High Recovery Light

Page 26

CONTROLS

LOW SOLUTION LIGHT

Figure 20

LOW SOLUTION LIGHT

The low solution warning light is located on the instrument panel as shown in figure 20. The low solution warning light illuminates when the solution tank is empty, marking the end of the scrubbing cycle.

HIGH RECOVERY LIGHT

Figure 21

HIGH RECOVERY LIGHT

The high recovery warning light is located on the instrument panel as shown in figure 21. The light will illuminate approximately 5 minutes before the recovery tank is full, giving ample time to complete the scrubbing cycle, before the mechanical float shuts off the vacuum to the recovery tank.

1-26

AMERICAN-LINCOLN

 

SMART

Image 26
Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table ABREVIATIONS-SETSCREWS Hardware AbreviationsABBREVIATIONS-SCREWS Standard Hardware & Torque Values SAE GradeHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Ordering Parts Parts may be ordered from Alto distributorsSafety Precautions Hazard Seriousness Level Personal SafetyMachine Safety Safety Precautions Specifications Scrubbing System WarrantyInstruments and Controls SqueegeeLWA Machine Preparation Unpacking and Assembling MachineUnpacking Battery Battery Installation Controls KEY Switch Forward / Reverse SwitchBattery Condition Meter Hour MeterHEADLIGHT/TAILIGHT Switch Optional Hopper Open Light WarningFilter Shaker Switch Only models with dust control Dust Control SwitchScrub Brush Switch Squeegee SwitchLOW Solution Light High Recovery LightHopper Lift Switch Side Broom and Main Broom SwitchSpray and VAC Wand Switch Optional Side Broom Adjustment Main Broom AdjustmentSolution Flow Knob Horn ButtonFoot Throttle Parking BrakeSeat Position Adjustment Safety FeaturesPRE-START Checklist Operating InstructionsTo Start Machine To Transport MachineTo Begin the Cleaning Operation Scrubbing the Average Floor with Light to Medium SoilageNON-RECYCLING or Standard Scrubbing Mode Floor ContactESP Operating Mode Scrub Brush Squeegee Floor ContactTo Stop the Cleaning Operation Scrubbing PathPost Operation Checklist To Drain Recovery TankRecovery Tank Hose Disk Scrub Brushes Operating Instructions Dust Control Knob Hydraulic Reservoir Level Sight GaugeHour Weekly Maintenance Checklist MaintenanceService Chart Hour Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Scrub Brushes Replacing Pads on a PAD DriverReplacing Rear Squeegee Draining the Recovery Tank Draining the Solution TankAdjusting the Main Broom Height Main Broom Access Door Replacing the Main BroomBroom Lift ARM Broom Idler Side Broom Adjustment Knob Dust Control Filter Cleaning the Dust Control FilterReplacing the Dust Control Filter When Damage is Evident Checking the Dust Control FilterDust Flaps Adjusting the Dust FlapsCleaning the Hydraulic System Checking the Dust FlapsTroubleshooting Problem Probable CauseRemedy