Nilfisk-ALTO 692003 manual American-Lincoln

Page 1

American-Lincoln®

 

SMART

Operator's Manual

Sweeper/Scrubber

Beginning with Serial No. 692003

READ THIS BOOK

This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your machine could result in injury to you or to other personnel. Damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If you or your operator (s) cannot read English, have this manual explained fully before attempting to operate this machine.

ISO 9001

All directions given in this book are as seen from the operator's position at the rear of the machine.

U® L

FILE#A2287

For new books, write to: American-Lincoln, 1100 Haskins Road, Bowling Green, Ohio 43402

Part No. 2-86-00321

2003 American-Lincoln®

Printed in the USA

AMERICAN-LINCOLN

1-1

SMART

 

Image 1
Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table ABBREVIATIONS-SCREWS Hardware AbreviationsABREVIATIONS-SETSCREWS SAE Grade Standard Hardware & Torque ValuesHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Parts may be ordered from Alto distributors Ordering PartsSafety Precautions Machine Safety Personal SafetyHazard Seriousness Level Safety Precautions Specifications Instruments and Controls WarrantyScrubbing System SqueegeeLWA Unpacking and Assembling Machine Machine PreparationUnpacking Battery Battery Installation Controls Forward / Reverse Switch KEY SwitchHour Meter Battery Condition MeterHopper Open Light Warning HEADLIGHT/TAILIGHT Switch OptionalDust Control Switch Filter Shaker Switch Only models with dust controlSqueegee Switch Scrub Brush SwitchHigh Recovery Light LOW Solution LightSide Broom and Main Broom Switch Hopper Lift SwitchSpray and VAC Wand Switch Optional Main Broom Adjustment Side Broom AdjustmentHorn Button Solution Flow KnobParking Brake Foot ThrottleSafety Features Seat Position AdjustmentOperating Instructions PRE-START ChecklistTo Transport Machine To Start MachineScrubbing the Average Floor with Light to Medium Soilage To Begin the Cleaning OperationFloor Contact NON-RECYCLING or Standard Scrubbing ModeScrub Brush Squeegee Floor Contact ESP Operating ModeScrubbing Path To Stop the Cleaning OperationTo Drain Recovery Tank Post Operation ChecklistRecovery Tank Hose Disk Scrub Brushes Operating Instructions Hydraulic Reservoir Level Sight Gauge Dust Control KnobService Chart MaintenanceHour Weekly Maintenance Checklist Hour Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Pads on a PAD Driver Replacing Scrub BrushesReplacing Rear Squeegee Draining the Solution Tank Draining the Recovery TankAdjusting the Main Broom Height Replacing the Main Broom Main Broom Access DoorBroom Lift ARM Broom Idler Side Broom Adjustment Knob Replacing the Dust Control Filter When Damage is Evident Cleaning the Dust Control FilterDust Control Filter Checking the Dust Control FilterCleaning the Hydraulic System Adjusting the Dust FlapsDust Flaps Checking the Dust FlapsProblem Probable Cause TroubleshootingRemedy