Nilfisk-ALTO 692003 manual Main Broom Access Door, Replacing the Main Broom

Page 54

MAINTENANCE

MAIN BROOM ACCESS DOOR

Fig. 81

MAIN BROOM ACCESS DOOR

The main broom access door is located in front of the left side tire of the machine as shown in figure 81. The door provides access to the main broom for service or inspection. The hopper must be raised to access.

WARNING

Engage hopper safety arm while accessing the main broom

BROOM LIFT ARM KNOBS

BROOM LIFT ARM WITH KNOBS REMOVED

Fig. 82

Fig. 83

REPLACING THE MAIN BROOM

The Main Broom should be replaced when the bristles become worn to less than 1 1/2”. The main broom is held in place by the right side broom door. This feature provides for easy removal and installation of the main broom without the need for special tools or equipment. Lift the hopper to gain access to the main broom compartment. Loosen the main broom access door knob and open the main broom access door. Rotate and remove the broom lift arm knobs counterclockwise to the left as shown in figure 82 and 83.

1-54

AMERICAN-LINCOLN

 

SMART

Image 54
Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table Hardware Abreviations ABBREVIATIONS-SCREWSABREVIATIONS-SETSCREWS Standard Hardware & Torque Values SAE GradeHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Ordering Parts Parts may be ordered from Alto distributorsSafety Precautions Personal Safety Machine SafetyHazard Seriousness Level Safety Precautions Specifications Scrubbing System WarrantyInstruments and Controls SqueegeeLWA Machine Preparation Unpacking and Assembling MachineUnpacking Battery Battery Installation Controls KEY Switch Forward / Reverse SwitchBattery Condition Meter Hour MeterHEADLIGHT/TAILIGHT Switch Optional Hopper Open Light WarningFilter Shaker Switch Only models with dust control Dust Control SwitchScrub Brush Switch Squeegee SwitchLOW Solution Light High Recovery LightHopper Lift Switch Side Broom and Main Broom SwitchSpray and VAC Wand Switch Optional Side Broom Adjustment Main Broom AdjustmentSolution Flow Knob Horn ButtonFoot Throttle Parking BrakeSeat Position Adjustment Safety FeaturesPRE-START Checklist Operating InstructionsTo Start Machine To Transport MachineTo Begin the Cleaning Operation Scrubbing the Average Floor with Light to Medium SoilageNON-RECYCLING or Standard Scrubbing Mode Floor ContactESP Operating Mode Scrub Brush Squeegee Floor ContactTo Stop the Cleaning Operation Scrubbing PathPost Operation Checklist To Drain Recovery TankRecovery Tank Hose Disk Scrub Brushes Operating Instructions Dust Control Knob Hydraulic Reservoir Level Sight GaugeHour Weekly Maintenance Checklist MaintenanceService Chart Hour Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Scrub Brushes Replacing Pads on a PAD DriverReplacing Rear Squeegee Draining the Recovery Tank Draining the Solution TankAdjusting the Main Broom Height Main Broom Access Door Replacing the Main BroomBroom Lift ARM Broom Idler Side Broom Adjustment Knob Dust Control Filter Cleaning the Dust Control FilterReplacing the Dust Control Filter When Damage is Evident Checking the Dust Control FilterDust Flaps Adjusting the Dust FlapsCleaning the Hydraulic System Checking the Dust FlapsTroubleshooting Problem Probable CauseRemedy