Nilfisk-ALTO 692003 manual Spray and VAC Wand Switch Optional

Page 28

CONTROLS

SPRAY VACCUM

Figure 24

SPRAY AND VAC WAND SWITCH (Optional)

The spray and vac wand switch is located on the instrument panel as shown in figure 24. Pressing the bottom half of switch turns on the vacuum motor and the solution pump. Pressing the top half of the switch turns the vacuum motor and solution pump off.

ESP

Figure 25

ESP SWITCH (Optional)

The ESP switch is located on the instrument panel as shown in figure 24. The ESP switch transfers water from the recovery tank through a filter and into the solution tank. When the switch is in the down position the pump will operate when the high recovery light is illuminated. Clean the recovery tank when the tank is emptied.

NOTE

Do not place clean water in the recovery tank when using ESP option, the solution tank could become overfilled during operation.

1-28	AMERICAN-LINCOLN
	SMART

Image 28

Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table ABBREVIATIONS-SCREWS Hardware AbreviationsABREVIATIONS-SETSCREWS Standard Hardware & Torque Values SAE GradeHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Ordering Parts Parts may be ordered from Alto distributorsSafety Precautions Machine Safety Personal SafetyHazard Seriousness Level Safety Precautions Specifications Warranty Instruments and ControlsScrubbing System SqueegeeLWA Machine Preparation Unpacking and Assembling MachineUnpacking Battery Battery Installation Controls KEY Switch Forward / Reverse SwitchBattery Condition Meter Hour MeterHEADLIGHT/TAILIGHT Switch Optional Hopper Open Light WarningFilter Shaker Switch Only models with dust control Dust Control SwitchScrub Brush Switch Squeegee SwitchLOW Solution Light High Recovery LightHopper Lift Switch Side Broom and Main Broom SwitchSpray and VAC Wand Switch Optional Side Broom Adjustment Main Broom AdjustmentSolution Flow Knob Horn ButtonFoot Throttle Parking BrakeSeat Position Adjustment Safety FeaturesPRE-START Checklist Operating InstructionsTo Start Machine To Transport MachineTo Begin the Cleaning Operation Scrubbing the Average Floor with Light to Medium SoilageNON-RECYCLING or Standard Scrubbing Mode Floor ContactESP Operating Mode Scrub Brush Squeegee Floor ContactTo Stop the Cleaning Operation Scrubbing PathPost Operation Checklist To Drain Recovery TankRecovery Tank Hose Disk Scrub Brushes Operating Instructions Dust Control Knob Hydraulic Reservoir Level Sight GaugeMaintenance Service ChartHour Weekly Maintenance Checklist Hour Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Scrub Brushes Replacing Pads on a PAD DriverReplacing Rear Squeegee Draining the Recovery Tank Draining the Solution TankAdjusting the Main Broom Height Main Broom Access Door Replacing the Main BroomBroom Lift ARM Broom Idler Side Broom Adjustment Knob Cleaning the Dust Control Filter Replacing the Dust Control Filter When Damage is EvidentDust Control Filter Checking the Dust Control FilterAdjusting the Dust Flaps Cleaning the Hydraulic SystemDust Flaps Checking the Dust FlapsTroubleshooting Problem Probable CauseRemedy