Nilfisk-ALTO 692003 manual Battery Removal with the Battery Rollout Option

Page 49

MAINTENANCE

BATTERY REMOVAL WITH THE BATTERY ROLLOUT OPTION

When removing batteries

1.Lift the machine front cover to access battery compartment.

2.Unplug the battery power connector from the machine power connector.

3.Line up battery cart locator pins with slots in frame and lock in place.

4.Rotate the battery lever to the right.

5.Roll battery out on to cart.

LINE UP BATTERY CART LOCATOR PINS

TO THE SLOTS IN THE FRAME

BATTERY CART

Fig. 67

Fig. 68

BATTERY LEVER

BATTERY CART

BATTERY CART

BATTERY LEVER

Fig. 69

Fig. 70

AMERICAN-LINCOLN	1-49
SMART

Image 49

Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table ABBREVIATIONS-SCREWS Hardware AbreviationsABREVIATIONS-SETSCREWS SAE Grade Standard Hardware & Torque ValuesHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Parts may be ordered from Alto distributors Ordering PartsSafety Precautions Machine Safety Personal SafetyHazard Seriousness Level Safety Precautions Specifications Instruments and Controls WarrantyScrubbing System SqueegeeLWA Unpacking and Assembling Machine Machine PreparationUnpacking Battery Battery Installation Controls Forward / Reverse Switch KEY SwitchHour Meter Battery Condition MeterHopper Open Light Warning HEADLIGHT/TAILIGHT Switch OptionalDust Control Switch Filter Shaker Switch Only models with dust controlSqueegee Switch Scrub Brush SwitchHigh Recovery Light LOW Solution LightSide Broom and Main Broom Switch Hopper Lift SwitchSpray and VAC Wand Switch Optional Main Broom Adjustment Side Broom AdjustmentHorn Button Solution Flow KnobParking Brake Foot ThrottleSafety Features Seat Position AdjustmentOperating Instructions PRE-START ChecklistTo Transport Machine To Start MachineScrubbing the Average Floor with Light to Medium Soilage To Begin the Cleaning OperationFloor Contact NON-RECYCLING or Standard Scrubbing ModeScrub Brush Squeegee Floor Contact ESP Operating ModeScrubbing Path To Stop the Cleaning OperationTo Drain Recovery Tank Post Operation ChecklistRecovery Tank Hose Disk Scrub Brushes Operating Instructions Hydraulic Reservoir Level Sight Gauge Dust Control KnobService Chart MaintenanceHour Weekly Maintenance Checklist Hour Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Pads on a PAD Driver Replacing Scrub BrushesReplacing Rear Squeegee Draining the Solution Tank Draining the Recovery TankAdjusting the Main Broom Height Replacing the Main Broom Main Broom Access DoorBroom Lift ARM Broom Idler Side Broom Adjustment Knob Replacing the Dust Control Filter When Damage is Evident Cleaning the Dust Control FilterDust Control Filter Checking the Dust Control FilterCleaning the Hydraulic System Adjusting the Dust FlapsDust Flaps Checking the Dust FlapsProblem Probable Cause TroubleshootingRemedy