Nilfisk-ALTO 692003 manual Foot Throttle, Parking Brake

Page 31

CONTROLS

FOOT THROTTLE

Figure 30

FOOT THROTTLE

The foot throttle is located to the right of the brake pedal on the floor of the operator’s compartment as shown in figure 30. This pedal controls the machine travel speed. Press the forward/reverse switch to chose the travel direction, and then press down on the foot throttle to move set the machine in motion. Increase the foot pressure to increase the travel speed.

PEDAL LOCK

BRAKE PEDAL

Figure 31

PARKING BRAKE

The parking brake is located on the floor of the machine left of the foot throttle as shown in figure 31. To set the parking brake, press down on the foot pedal and the press down the lock. To unlock the parking brake, push down on the upper portion of the foor pedal and release.

AMERICAN-LINCOLN

1-31

SMART

 

Image 31
Contents American-Lincoln AMERICAN-LINCOLN Index Disclaimer DisclaimerDecimal Metric Conversion Table ABBREVIATIONS-SCREWS Hardware AbreviationsABREVIATIONS-SETSCREWS SAE Grade Standard Hardware & Torque ValuesHydraulic Torque Requirements Hydraulic Torque RequirementsSymbols Parts may be ordered from Alto distributors Ordering PartsSafety Precautions Machine Safety Personal SafetyHazard Seriousness Level Safety Precautions Specifications Squeegee WarrantyInstruments and Controls Scrubbing SystemLWA Unpacking and Assembling Machine Machine PreparationUnpacking Battery Battery Installation Controls Forward / Reverse Switch KEY SwitchHour Meter Battery Condition MeterHopper Open Light Warning HEADLIGHT/TAILIGHT Switch OptionalDust Control Switch Filter Shaker Switch Only models with dust controlSqueegee Switch Scrub Brush SwitchHigh Recovery Light LOW Solution LightSide Broom and Main Broom Switch Hopper Lift SwitchSpray and VAC Wand Switch Optional Main Broom Adjustment Side Broom AdjustmentHorn Button Solution Flow KnobParking Brake Foot ThrottleSafety Features Seat Position AdjustmentOperating Instructions PRE-START ChecklistTo Transport Machine To Start MachineScrubbing the Average Floor with Light to Medium Soilage To Begin the Cleaning OperationFloor Contact NON-RECYCLING or Standard Scrubbing ModeScrub Brush Squeegee Floor Contact ESP Operating ModeScrubbing Path To Stop the Cleaning OperationTo Drain Recovery Tank Post Operation ChecklistRecovery Tank Hose Disk Scrub Brushes Operating Instructions Hydraulic Reservoir Level Sight Gauge Dust Control KnobHour Maintenance Checklist MaintenanceService Chart Hour Weekly Maintenance Checklist11, 12 Maintenance Battery Charging Instructions Battery Removal Battery Removal with the Battery Rollout Option Replacing Pads on a PAD Driver Replacing Scrub BrushesReplacing Rear Squeegee Draining the Solution Tank Draining the Recovery TankAdjusting the Main Broom Height Replacing the Main Broom Main Broom Access DoorBroom Lift ARM Broom Idler Side Broom Adjustment Knob Checking the Dust Control Filter Cleaning the Dust Control FilterReplacing the Dust Control Filter When Damage is Evident Dust Control FilterChecking the Dust Flaps Adjusting the Dust FlapsCleaning the Hydraulic System Dust FlapsProblem Probable Cause TroubleshootingRemedy