Chapter 3 Display/Operation Panel
ARRAY OPTIONS | Page 3 - 13 |
UNIT ATTENTION
Clear Password
Clear a password as follows:
1.)81&7,216(/(&7Press the down arrow,then$55press$<237,216the right or left arrows until is displayed.
2.Press the down arrow.
3.Press the right or left arrows until the 3$66:25'menu is displayed.
4.Press the down arrow to view the &/($53$66:25'menu. If (17(5 3$66:25'is displayed, press the right key once to show &/($5
5.Press the down arrow.
6.Press the right arrow once to display <(6then press SELECT. The panel immediately displays &/($5(', and password protection is cleared from the array.
If your system cannot handle SCSI bus errors reported with a SCSI UNIT ATTENTION$77(17,21signal, use this option to keep the array from doing so. 81,7
is typically set to 21. Setting 81,7$77(17,21to 2))will result in some error messages, such as Drive Failure and Reset, not being reported over the SCSI bus. When active, an alarm will sound and a message will display.
WRITE | Setting :5,7(3527(&7to 21prevents any data from being written to the | |
PROTECT | array. This is typically set to 2)). | |
ALARM | This menu allows turning the audible alarm on and off. The audible alarm turns | |
| on when any of the following conditions occur in the array: | |
| • | Disk drive fails |
| • | |
| To silence the alarm temporarily when it is active, press any key to turn off the | |
| alarm. The $/$50setting is typically set to 21. | |
6500 Disk Array User’s Guide | 21020690 B |