Integra DTR-7.3 instruction manual Connecting speakers, Using the speaker labels

Page 21

Connecting speakers

Connecting speakers

After determining the layout of your speaker system, it is now necessary to connect the speakers correctly to your DTR-7.3.

Caution:

Connect only speakers with an impedance between 4 and 16 Ω to the DTR-7.3. If the impedance of even one speaker is between 4 and 6 Ω, be sure to set the speaker impedance setting accordingly (see page 41).

Notes:

•Even if you are using only one speaker or listening to monaural (mono) sound, never connect a single speaker in parallel to both the right and left-channel terminals.

Using the speaker labels

The positive speaker terminals on the DTR-7.3 are color coded for easy identification. Attach the supplied speaker labels to the speaker cables, and then match the colors on the speaker cables to the corresponding terminals.

Speaker cable label

DTR-7.3

Speaker

Speaker cable label

SPEAKERS

– +

LL

RR

–+

•To prevent damage to circuitry, never short-circuit the positive (+) and negative (–) speaker wire.

NO!

SPEAKERS

–+

LL

RR

–+

The speaker channels are colored as follows: Front left speaker (+): White

Front right speaker (+): Red

Center speaker (+): Green

Surround left speaker (+): Blue

Surround right speaker (+): Grey

Surround back/Zone 2 left speaker (+): Brown

Surround back/Zone 2 right speaker (+): Tan

•Be sure to connect the positive and negative cables for the speakers properly. If they are mixed up, the left and right signals will be reversed and the audio will sound unnatural.

•Do not connect more than one speaker cable to one speaker terminal. Doing so may damage the DTR-7.3.

•Connect either your surround back speakers or the speakers you will be using in the remote zone (Zone 2) to the SURR BACK SPEAKERS/ZONE 2 SPEAKERS terminals (see page 24).

Use the PRE OUT SUBWOOFER

 

 

Front right

Front left

Surround right

 

Surround left

 

Subwoofer

speaker

speaker

 

speaker

 

speaker

jack to connect a subwoofer with a

 

 

 

 

 

 

 

 

 

 

 

built-in power amplifier. If your

 

 

 

 

 

 

 

 

subwoofer does not have a built-in

 

 

 

 

 

 

 

 

amplifier, connect an amplifier to

 

 

 

 

 

 

 

 

the PRE OUT SUBWOOFER jack

 

 

 

 

 

 

 

 

and the subwoofer to the amplifier.

 

 

 

 

 

 

 

 

DIGITAL

PRE OUT

ANTENNA

AUDIO

VIDEO S VIDEO

COMPONENT

FRONT SPEAKERS

SURR SPEAKERS

 

INPUT

R L

 

 

VIDEO

 

COAX

FRONT

 

 

MONITOR

OUTPUT

R

L

R

L

AV RECEIVER

1

 

 

 

OUT

Y

 

 

 

 

MODEL NO. DTR-7.3

R L

 

 

SUB

CENTER

 

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

AM

OUT

ZONE 2

PB

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SURR

 

 

 

 

 

 

 

 

 

 

 

AC OUTLETS

3

 

 

 

 

 

IN

DVD

PR

 

 

 

 

 

 

 

 

SURR

L

 

 

 

 

 

 

 

 

 

 

 

OPT

 

BACK/ R

 

 

 

 

INPUT 1

 

 

 

 

 

 

 

ZONE 2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FM

 

 

 

 

 

 

 

 

 

1

 

 

 

 

OUT

 

Y

ETHERNET

 

 

 

 

 

 

 

 

 

75

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ConnFROeNT cting theMULTI speakerCH

cable

VIDEO 1

 

[NET-TUNE]

 

 

 

 

 

 

 

 

 

 

 

SURR

 

 

 

 

CENTER

 

 

 

 

2

 

PB

 

 

 

BACK/

 

 

 

INPUT

 

 

IN

 

 

 

 

 

 

 

R

 

AUDIO

 

 

 

SPEAKER

 

 

 

ZONE 2

 

 

 

L

 

 

 

 

 

 

 

AC 120V 60 Hz

 

 

R

L

 

 

 

CAUTION:

 

 

 

SPEAKERS

 

 

SUB

CENTER

 

 

 

 

 

SPEAKER

 

 

 

 

SWITCHED

 

 

 

 

 

 

 

 

 

 

TOTAL 120W 1A MAX.

 

1. Strip away approx. 5/8 inch (15 mm) of

 

 

 

 

3

 

 

 

 

PHONO

OUT

 

PR

IMPEDANCE

 

 

 

 

 

 

 

the wire insulation.

 

VIDEO 2

 

4 OHMS MIN. OR

 

R

 

L

 

 

 

 

INPUT 2

6 OHMS MIN.

 

 

 

 

 

SURR

 

 

 

 

 

/SPEAKER

 

 

 

 

 

DIGITAL

 

 

 

CD

IN

 

Y

SEE INSTRUCTION

I R

 

 

AC INLET

 

OUTPUT2.

Twist the wire ends tightly together.

 

 

MANUAL FOR

 

A

ZONE 2

 

 

 

 

R

L

 

OUT

 

 

 

CORRECT SETTINGS.

 

 

12V

 

 

 

3.

UnscrewSURR

 

 

 

 

 

IN

 

TRIGGER OUT

 

 

OPT

 

 

 

IN

VIDEO 3

PB

 

RS232

 

 

 

 

 

the speaker terminal cap.

 

 

 

 

 

 

 

 

 

 

BACK

 

 

TAPE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4.

Insert the exposed wire end.

IN

VIDEO 4

PR

B

 

 

GND

 

 

IN

 

 

OUT

REMOTE

5.

R

L

R

L

capVIDEO . S VIDEO

 

 

CONTROL

Screw down theAUDIOspeaker terminalAUDIO

 

 

 

123 45

5/8"

(15mm)

Center

Surround Back

Surround Back

 

speaker

right speaker

left speaker

21

 

 

 

Page 20 Page 22
Image 21
Page 20 Page 22
Contents DTR-7.3 Avis Important SafeguardsPrecautions Contents Contents Supplied accessories FeaturesBefore using this unit Installing the remote controller batteriesUsing the remote controller Front panel Index parts and facilitiesIndex parts and facilities Front panel display Remote controller Mode buttons and indicators 28 Send/Learn indicatorOn/Standby button Sleep buttonRear panel Connecting to Audio/Video equipment Connecting your audio components Connecting to Audio/Video equipmentConnecting a compact disc player CD Connecting a turntable PhonoConnecting a DVD Player Connecting your video componentsFlow of the video signals is as follows Connecting a DVD player DVDConnecting a video cassette recorder Video Connecting a television monitor or projector Monitor OUTSignal flow Video Connecting video camera, etc. Video 5 InputIdeal speaker configuration Connecting speakersMinimum speaker configuration for surround sound playback Speaker placementConnecting speakers Connecting speakersUsing the speaker labels Connecting the AM antenna cable Connecting antennasConnecting the included antennas Assembling the AM loop antennaConnecting antennas When using the Surr BACK/ZONE 2 Speakers terminals Connecting the remote zone Zone 2 speakersWhen using the Zone 2 OUT terminals When using the Surr BACK/ZONE 2 PRE OUT terminalsIR OUT Connecting the power cords from other devices Connections for remote controlMiscellaneous Connections RS 232 portConnecting to devices with analog multi channel output Connecting to an external device with 12V Trigger terminalConnecting auxiliary power amplifier Miscellaneous ConnectionsConnecting the power Turning on the powerTurning on the power from the remote controller Enjoying music or videos with the DTR-7.3 Basic operationTo change the display of the input source from Tape to MD Listening with headphones Adjusting the bass and trebleUsing the sleep time remote controller only Enjoying music or videos with the DTR-7.3Setup Enter Return Changing the listening modeWhile playing back DTS sources While playing back Analog/PCM sourcesSwitching the display Adjusting the brightness of the front displayTemporarily changing the speaker output levels Enjoying the multichannel output Changing the audio modeTuning into a radio station Listening to a stereo radio station FM modeListening to Radio Broadcasts Selecting a preset radio station Presetting a radio stationErasing a preset radio station Listening to Radio BroadcastsUsing the buttons on the DTR-7.3 Adjusting the volume for the remote zoneEnjoying music in the remote zone Recording a source Rec OutStart recording at the recording component as desired Press the Rec Out button Recording a sourceSetup Menu Basic MenuAdvanced Menu Setup Menu Navigating through the Setup MenuPress the Setup button Hardware Setup Menu Hardware SetupSurr Back/Zone 2 Sub-menu Speaker Impedance Sub-menuIR in Setup Sub-menu Hardware SetupSpeaker Setup Speaker Setup MenuSpeaker Config Sub-menu Speaker Distance Sub-menu Speaker SetupPress the Test button to complete the procedure Using the remote controller Press the Test buttonLevel Calibration Sub-menu Calibrating the speaker levelsInput Setup Menu Input SetupInitial settings for each input source Digital InputInput Setup Digital FormatInput source selected Multichannel Last Valid enables the source last selected Select to have Video Setup Sub-menuVideo Component VideoIntelliVolume IntelliVolume Sub-menuCharacter Input Sub-menu Character DisplayRelationship between input source and listening mode Listening Mode Preset Sub-menuListening Mode Type of softwareListening Modes Input source signalsTrigger Setup Sub-menu Audio Adjust Setup Menu Audio AdjustSetting Values Initial value Tone Control Sub-menuAudio Adjust Delay Sub-menuSound Effect Sub-menu Theater Dimensional Sub-menu LFE Level Sub-menuMono Sub-menu Surround Sub-menu THX Sub-menu Listening mode Treble Setting Tone ControlSound Effect Bass Re-EQVolume Setup Sub-menu PreferencePreference Menu OSD Setup Sub-menu Headphones Level Setup Sub-menuPreference OSD Position Sub-menuRcvr Mode Using remote controllerOverview Controlling an Integra/Onkyo cassette tape deckControlling an Integra/Onkyo DVD player Using remote controllerOn Standby CD Mode Disc Press the CD Mode buttonControlling an Integra/Onkyo CD player Press the SAT/MD Mode button On Standby SAT/MD ModeControlling an Integra/Onkyo MD recorder Rec RecordLearning a pre-programming code Entering a pre-programming codeVOL DisplaySetting No Entering a pre-programming codePre-programming codes DVD Mode DVD Player Mode Operating your programmed remote controllerSAT Mode Satellite Tuner Mode Cable Mode Cable ModeOperating your programmed remote controller VCR Mode VCR ModeTV Mode TV Mode Light Macro 1 Macro Programming procedureErasing all the commands programmed under a Mode button Erasing the programmed command from one buttonPress and release the same Mode button again Press and release the same button againWhat is the macro function? Using the macro functionProgramming the macro Executing the macroUsing the macro function Erasing all commands and macros that have been programmedErasing a macro from the Macro 1 or 2 button Troubleshooting guide Video and Audio Troubleshooting guideIf one of the messages shown below appears Specifications Net-Tune Features Internet radio featuresModem To the WAN side To the LAN side port Connecting the DTR-7.3 to your Ethernet NetworkEnjoying Internet radio Enjoying Music on Internet Radio or NAS-2.3Playing a music file saved in NAS-2.3 Enjoying Music on Internet Radio or NAS-2.3To cancel the operation Using the Alphanumeric keysUse the / buttons to select one of the menu Caps Press the Enter buttonNetwork Setup Menu Configuring Various SettingsProxy Setup Sub-menu Configuring Various SettingsIP Address Sub-menu MAC Address Sub-menuTroubleshooting guide SpecificationsAppendix

DTR-7.3 specifications

The Integra DTR-7.3 is a state-of-the-art AV receiver designed for audiophiles and home theater enthusiasts who seek a blend of performance, flexibility, and advanced technology. With a powerful amplifier section, the DTR-7.3 delivers an exceptional audio experience, providing crystal-clear sound reproduction across all frequencies.

At the heart of the DTR-7.3 is the ability to deliver 9.2 channels of amplification, making it an ideal choice for a comprehensive home theater setup. It supports various speaker configurations, allowing users to create immersive surround sound environments. The receiver is equipped with sophisticated DSP (Digital Signal Processing) that enhances audio fidelity while supporting multiple audio formats, including Dolby Atmos, DTS:X, and IMAX Enhanced. These technologies enable sound to move in a three-dimensional space, wrapping listeners in a dynamic auditory experience.

One of the standout features of the DTR-7.3 is its 4K Ultra HD video capabilities, ensuring that users can enjoy high-quality imagery with up to 60 frames per second. The receiver is equipped with HDR (High Dynamic Range) support, allowing for deeper contrast and more vibrant colors. Additionally, it includes multiple HDMI inputs and outputs, making it easy to connect to various devices, including gaming consoles, Blu-ray players, and streaming devices.

Connectivity is also a strong suit of the DTR-7.3. It supports Wi-Fi, Bluetooth, and Ethernet, granting users the ability to stream music from a variety of online services without the hassle of physical connections. The receiver is compatible with various music streaming protocols such as AirPlay, Spotify Connect, and TIDAL, allowing for seamless access to a vast library of audio content.

The DTR-7.3 also includes an advanced room calibration system that optimizes sound according to the specific acoustics of the room. This feature automates the tuning process, ensuring that every listening position benefits from balanced sound.

In addition, the user-friendly interface and the Integra Remote App make it easy to operate, allowing users to control their home theater setup from their smartphones or tablets. With its impressive combination of features, advanced technologies, and easy connectivity, the Integra DTR-7.3 stands out as a top-tier choice for anyone looking to elevate their home entertainment experience.
Top Page Image Contents