FILLING SOLUTION TANK
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.
1.Turn the machine power off.
2.Remove solution cover.
3.Fill the solution tank with clean water, leaving enough room for the required amount of cleaning solution. The solution tank capacity
filled to fill inlet is 25 gallons (95 liters). The water must not be hotter than 140 F (60C) to prevent damage to the tank.
4.Measure the chemical into the solution tank. Liquid chemicals should be added to the solution tank after filling with water. Dry chemicals should be thoroughly mixed before being added into solution tank. Commercially available, high alkaline floor cleaners, are suitable for use in the solution system.
NOTE: Read the chemical manufacturers recommended proportion instructions.
5.Replace solution tank cover.
Flammable materials can cause an
explosion or fire. Do not use flammable materials in the tanks.
MACHINE OPERATION
NORMAL SCRUBBING
Plan the scrubbing pattern in advance. The longest track is around the perimeter of the area to be cleaned. For efficient operation, the runs should be the longest possible without turning, stopping, or raising or lowering scrub deck/squeegee.
In order to achieve the best possible results, the area which is to be cleaned should be swept before scrubbing. Large debris, strings and wire must be removed to prevent being caught in brushes or squeegee.
If the machine is allowed to stand in neutral with the scrub deck down for more than 2 seconds, the solutions flow stops and brush motors stop. If either forward or reverse travel is selected, the solution flow will continue in the same setting and the scrub brush motors will continue in their same setting once movement of machine begins. Overlap the brush path and avoid transporting over previously cleaned areas.
86037660 CHARIOT 11/09/06 |
|