Finalizing the Installation | 2 7 |
1Remove the glass frame (and arch covers) following the directions below. Warning: The appliance must be completely cool before removing the glass.
N o t e : If using an arch face, attach the arch covers after
Spring Pin
Open the four latches holding the glass
a frame in place (start with the bottomTop of
Firebox
two) - follow the directions shown to the right.
Glass
| Glass Frame |
|
b | Lift the glass frame up and |
|
pull it forward to remove. | NOTE: | |
|
| |
|
| You may need to lift |
|
| the glass frame |
|
| while |
Re-Attaching the Glass Frame:
a)Hang the glass frame on the firebox.
b)While holding in place, attach the upper latches
Insert the 1/4” key into the spring pin.
Twist 1/4 turn.
(follow the instructions to the right in reverse).
Latch Bracket
The spring pin will disengage from the
c) Lift the glass frame slightly and attach the lower latches.
Arch Covers (both sides)
latch bracket, opening the latch.
Glass
Frame
Arch Cover
Glass
The arch covers (included in the owner's pack) block light from exiting the scroll work on arched faces.
The covers hang on the glass frame.
Arch Faces:
Attach arch covers before installing the face.
Rectangular Faces:
Discard the arch covers.
Travis Industries | 4040708 | 1 0 0 - 0 1 1 6 0 |