FireplaceXtrordinair 36 DV EFIII owner manual 4Operation, Starting The Pilot Flame

3 4Operation

Starting The Pilot Flame

a

The pilot flame is required to ignite the main burners (it also plays a safety role). It should be left on once lit. It will stay lit unless the gas control valve is turned to "OFF". However, the pilot will go out if the gas is shut off, the propane tank runs out (or low) or if the stove malfunctions. If the pilot turns off frequently, call your dealer for information. To start the pilot follow the directions below:

b

WARNING:

When lighting or re-lighting the pilot, the glass must be removed (see page 27).

aRemove the glass (see page 27 for details).

b Push the gas control knob in slightly and turn

it to the "OFF" position. The knob will not c turn from "ON" to "OFF" unless the knob is depressed slightly. Wait five minutes to let

any gas that may have accumulated inside the firebox escape. If you smell leaking gas, follow the directions on the cover "IF YOU SMELL GAS".

c Turn the gas control knob to the "PILOT"

position and press the knob in, this will allow d gas to flow to the pilot light. Press the

button on the pilot igniter repeatedly until you see the pilot light.

WARNING:

If the pilot does not light after 15 seconds, release the knob and call your dealer for service. Do not

e

attempt to light pilot until service has been performed.

N O T E :

You may wish to remove the log set to gain a better view of the pilot (see page 28).

d Keep the gas control knob depressed for 30	f
seconds once it is lit.

e Release the gas control knob. If the pilot goes out, repeat step C. If the pilot refuses to stay lit, call your dealer for service. With the pilot lit, proceed to step “f”.

f Replace the glass.

g

g Turn the gas control knob counter-clockwise to "ON". The pilot is now lit and the heater can be turned on and off.

5 minutes

PILOT

IGNITER

30 seconds

?

Travis Industries 4040708 1 0 0 - 0 1 1 6 0