Outdoor Knight XL Installation & Operation Manual
2 Prepare boiler
Remove boiler from wood pallet
1.After removing the outer shipping carton from the boiler, remove the parts box.
2.Remove the front door to access the lag bolts in front of the unit (FIG.
3.To remove the boiler from the pallet (after removing the front door):
a.Remove the two lag bolts from the wood pallet inside the boiler (FIG.
b.Detach the boiler from the lag bolts in the rear of the unit, see FIG.
NOTICE | Do not drop the boiler or bump the |
jacket on the floor or pallet. Damage to | |
| the boiler can result. |
Figure 2-1 Boiler Mounted on Shipping Pallet
Install flue pipe assembly
Models 400 - 601
This unit is provided with all of the necessary venting components. All components must be installed prior to operation.
1.Locate all venting components from the installation kit and carton.
2.Before connecting the vent pipe sections or components, verify that the gasket is seated evenly inside the groove in the female end of the elbow and flue adaptor (FIG.
3.Remove the provided screws from the vent cover and use them to install the vent strap (FIG.
4.Insert the elbow into flue adaptor (FIG.
CAUTION | Do NOT use grease or other lubricant |
on the vent seals. Only water may be | |
| used for this purpose. Grease or other |
| lubricant can make the seal brittle or |
| cause tearing of the seal surface which |
| can result in flue gas leakage. |
5.Slide the vent pipe through the wall strap and insert it into the elbow (FIG.
6.Install the bird screen into the top of the vent.
Figure 2-2 Install flue pipe assembly - Models 400 - 601
. 2
WALL STRAP
AND SCREWS
BIRD SCREEN
VENT PIPE
ELBOW
IMG00444
FLUE
ADAPTER
NOTE: VERIFY THAT GASKET IS SEATED EVENLY
INSIDE THE GROOVE IN ELBOW AND ADAPTER
10