3.Press the “ENTER (RESET)” key.
4.The control will ask you to confirm the setting with the following screen:
Press “ENTER (RESET)” if the value is correct, or “CANCEL (BACK)” if it is not.
D. Temperature Low Limit Differential
1.In any mode or screen other than an OPTION sub- menu, press the “LOW DIFF” key.
2.The following screen will be displayed:
The temperature displayed is the current setting. Use the “▲” and “▼” keys to select the desired setting. Tap the button to increase or decrease the temperature by 1°, or hold it to increase or decrease the temperature by 5° at a time. The control will not allow you to select
Press the “ENTER (RESET)” key.
The control will ask you to confirm the setting with the following screen:
Press “ENTER (RESET)” if the value is correct, or “CANCEL (BACK)” if it is not.
Programming Additional Options
Note: Some additional menus may be visible that are not included in the following pages. Those menus are non- functional and reserved for future use.
Electrical Shock Hazard.
Can cause severe injury, death, or equipment damage.
Live line voltage wires and connections will be exposed while programming the AquaSmart. Take care to touch only the AquaSmart keypad while programming the control.
a.To toggle the fuel economizer on or off: Press “ENTER (RESET)” key.
b.To Adjust the Heat Manager efficiency setting: Press the “▲” or “▼” keys until the following screen is displayed:
Fire, Explosion, and Burn
Hazards.
Can cause severe injury, death, or equipment damage.
Do not set the operating limits of the control outside of those listed by the appliance manufacturer.
Press “ENTER (RESET)” to toggle the comfort setting between HI, MED, and LOW. See “HeatManager Technology” section for an explanation of the efficiency settings.
4.Press “CANCEL (BACK)” to exit.
A. Changing the Heat Manager Settings
1.In any mode or screen other than an OPTION sub- menu, press the “OPTION” key.
2.The following screen will be displayed:
Press “ENTER (RESET)” key.
3. The following screen will be displayed:
B. Viewing the Boiler Cycle History
1.In any mode or screen other than an OPTION sub- menu, press the “OPTION” key.
2.The following screen will be displayed:
Press the “▲” or “▼” keys until the following screen is displayed:
26